Howard Johnson Replication Tube Claim

[broli]

I suspect that the stator magnet loosing it's alignment or magnetic ability, and the reason the motor runs are probably related issues.  I would guess that the stator magnet having a pinning material that holds the magnetic particles in place (being weaker than the rotor mags) may be acting as a "flex" point that allows the motor to run for a while.  It will continue to run until the pinning material no longer holds the magnetic particles in alignment and then the stator magnet strength is weakened to the point that the motor will not continue to run.  Just a guess, but if a different magnet that is stronger and more permanent is used for the stator, but the motor does not run, it may indicate the reason why the motor is able to work.

This then can be easily solved by making a magnetic circuit. Put a strong permanent magnet far away from the rotor and make a magnetic circuit with a magnetic "flexible" material that's close to the rotor, it's that simple.

Problem = Solution

[Philip Hardcastle]

@Broli,

You misunderstand me.

I was passing on a point to the guy that did the video that he may give many people cause for doubt by having a temperature differential. All he needs do is take away the 100W lanp to the close right and video it with an even cool lamp.

I am not sure about the rest of your attack on me but if this is a forum I assume people should talk science not hate.

If there were a 0.1 deg C temperature difference then for 10 watts of heat at one side magneto work of 3.3millijoules might be possible. Now I am not saying it is because like you we are viewers.

So what I offer is my advice to this guy so that he can advance his claim.

The science world demands that all reasonable steps be taken in an experiment to eliminate not only the known but the possible unknowns such as I have raised.

He has the wheel built and I assume he knows from someone here (perhaps sterling) of any constructive views. That is what I offered.

So cut me some slack and think about what I said before you get aggressive.

PS while you are at it can you go to curled ballistic thermionics and tell me what I did wrong there.

Thanks

Phil H

Phil H

[broli]

Unlike you I don't care what professors think of my idea or am I worried whether I can please them. If I have an idea I will share it with the world and then try to inform and educate as much people about it so they can better their lives with it. While the professors are denying it millions are powering their home with it and opening their minds to the joke they call "life". I don't blame them though. They have been taught by ignorant people as well.

[dixiepnum]

Folks,

this is an open invitation to Sterling, Clanzer, and anyone else with a respected history here (all jokes aside). I am going to assume that this is not a hoax for the purposes of this discussion.

I am afraid Mylow is going to get overwhelmed and lost with all the competing interests, suggestions, and requests he is getting. I'm hoping to get him focused on the right priorities.

Can anyone suggest what the project plan should be for the next 6 months, to prevent this from ending up in the dustbin of OU magnetic perpetual inventions like many others on this site?

Even if we just discuss options for the project plan, at least it will give him some ideas for targets and milestones. He can't please everyone, but maybe we can point him in the right direction.

Once we have a list, we can get his attention with it on Youtube or through Sterling.

Any takers?

thanks

[Omnibus]

dixiepnum, are you willing to contribute to sending a trusted member of our community such as X00013 or CLaNZeR (better both of them) to visit MYLOW121363 and examine his claim?