Howard Johnson Replication Tube Claim

[Lakes]

There have been several very good builders try to replicate this now, Clanzer and Queue to name two, mylow has the same magnets as queue is using, unless he provides Queue with information to get his replication working this will be at a dead end.

[PaulLowrance]

Please forgive the following bad humor, and it's only that, but I couldn't resist,

Sterling Allan presents the following evidence ... Napkin Drawing! ... Ta Daaaaa!!!

[queue]

Sterling
Does this same spacing apply to m646 rotors and Hs811n stator that i have ? -
No guessing please - if you don't know say so..

Does he still have those 2 magnet sets  ?

He has had those m646 rotor magnets that you sent to him for more than a week now ..
and still no config  to replicate with ..

It seems to me that if he had those magnets working he could remember the working config and could easily answer the question i have put to him MANY times .. in both forums and on his youtube ( again last night ) 

What is the required spacing and layout for the M646 anf HS811n magnets ?
Magnets that both he and i have in common ..

.. i could replicate a config within hours of having that info yet he never provides it..

IMO it doesn't seem like he really wants someone to replicate  ..
if he did he would already have provided these info and it would be done..

Q

[lostcauses10x]

Hmm with people, there are them that try and do some things. They become delusional and believe in what they are doing.  Some have make fake videos of such hoping others; or just plain convinced: their idea or item works, or will work.
They proceed to get others involved in such, It is not at all abnormal for others to get caught up in such delusions. Happens all the time.

In this case I think Mylow is one that thinks what he has done is real.
I doubt it is.
  The MIB crap, ( well after the claim of a NSA official , some feds might have shown up) is just a part of the delusions of a person.
The whole story line from the start of this fits this pattern. It is not an open fake. It is a product of some ones delusions, and as usual forks have got caught up in it.

  As for Sterling visiting: Why not take everything to make it with you??? You showed a replication attempt.  LOL so he ends up with a few napkin drawings from a person who did not even know the polarity of his magnet motor lay out. Sterling you are now caught up in some ones paranoid delusions.  Don't worry it wont be long before you are a part of the (Out to get him) side of such.

[robbie47]

Today I had a look at what might cause the stator magnet to cool down.
Quick search on the Internet learned me that this is quite a common effect.

Now looking at this, theory learns that the cooling of the stator has degrading effect on the stator magnet.
This means at least two things:
1) there is energy transfer from the stator to the rotor magnets, meaning that this could be the driving energy for this setup.
2) if this driving effect is real, this setup has limitted lifetime until the rotor magnet has been worn out, something MYLOW mentioned several times.

It could also say something about the materials of the applied magnets, since this thermo magnetic effect does not occur with every magnetic material.
I conclude that the stator magnets MYLOW has used at least contain such materials and the rotor magnets less or none.

It would not surprise me if the thermo magnet effect is also the reason why other permanent magnet concepts like perediv, whipmag, etc are pulled back from publication due to limited lifetime of part of its magnets.

Still interesting though what would be the critical factors to activate this effect to drive a motor.

[just my thoughts....]

Attached a simple indication of the effect.