Howard Johnson Replication Tube Claim

[nyctuber]

Great Video.
But nothing has changed since his first
video of a spinning wheel.
so far we have seen at least 3 different
setups, maybe 4 . The fact still remains
that until someone verifies it, it is just a video.

When you get ready to listen to logic and
common sense I'll explain to you why it's
not what it appears to be.

And I'll bet that he nevers lets anyone physically
examine it.

And Just so you know. I too wanted it to be real.

Everyone here knows the logic/common sense reasons why it 'can't' be real. However, there are gaps in science when it comes to magnetism at the quantum level.  We all know it's useless unless it can be replicated.

[Digjam]

Everyone here knows the logic/common sense reasons why it 'can't' be real. However, there are gaps in science when it comes to magnetism at the quantum level.  We all know it's useless unless it can be replicated.

But the reasons it isn't real has nothing to do with magnetism.

I too believe a magnet motor is possible

[nyctuber]

But the reasons it isn't real has nothing to do with magnetism.

I too believe a magnet motor is possible

If you have a thought, then just state it.

It has most likely been covered in the 267 pages of the thread, but please be my guest.

[sterlinga]

I've uploaded a copy of the video:

----- Original Message -----
From: Sterling D. Allan
To: George Noory ; JR at Rense.com
Sent: Thursday, April 30, 2009 12:34 AM
Subject: SUCCESS: Fw: Mylow spinning motor w/ bar magnets


Check this out:
http://www.youtube.com/watch?v=K4GXGhEZ4qg

I'm composing a story here:
http://pesn.com/2009/04/30/9501533_Mylow-posts-running-bar-magnet-motor/


----- Original Message -----
From: Sterling D. Allan
To: Fred Burks
Sent: Thursday, April 30, 2009 12:01 AM
Subject: Fw: Mylow spinning motor w/ bar magnets



----- Original Message -----
From: Sterling D. Allan
To: Mylow Howard Johnson Motor egroup ; Mylow newsletter
Cc: NE Congress Tech Review egroup ; Jim Dunn
Sent: Wednesday, April 29, 2009 11:52 PM
Subject: Mylow spinning motor w/ bar magnets


http://www.youtube.com/watch?v=A4uVuK2Ec6Y

I'll be uploading it to the PESNetwork account.

[Digjam]

If you have a thought, then just state it.

It has most likely been covered in the 267 pages of the thread, but please be my guest.

The one thing he forgot about in all his videos
was Newton's 3rd law.
"For every action there is an equal and opposite
reaction"

now while in this last video the stator magnet
did move up and down .. you see absolutely
no radial movement of the stator arm.
There are 36 magnets on the rotor .
now I don't know what the rotor weighs, but I
am sure that it is much more than the stator
assembly.
The stator assembly is just sitting free on the
table. To turn the rotor at the speed that it turns
the stator assembly would move radially in the
opposite direction of the rotor rotation.Even if
it were glued down, it would flex.Therefore, the
Stator is NOT moving the rotor.

This can be observed in all of his videos where
the disk is spinning.