Howard Johnson Replication Tube Claim

[TheNOP]

it would do the same thing with a wooden disk.

the secrets are:  week magnet and the counter weight(disk not at level)
ask yourself why the counter weight seem to weight more then all the magnet added together.

[CLaNZeR]

Also, we don't know how fast the rotor PM's are degaussing. We know the stator degausses, but IMO the rotor PM's also degauss, just at a much slower rate. Remember, there are what, 63 stator PM's. That's a lot of PM energy loss.

PL

But Paul if Mylo's Rig is the real deal then this then proves that magnets can be configured to do the work but also pay the price in this config. But paying the price would be the next hurdle to overcome.

Getting them to do the work is the exciting part, you got to admit that

[AB Hammer]

Greetings CLaNZeR and all

The weekness of the iron magnet is interesting, When I did my wheel back in 1974 for a science project. I was using iron magnets as well. This got me thinking about a magnetic field test I did on Youtube.

http://www.youtube.com/watch?v=4tzXhOipIxE&feature=channel_page

The attraction seem to be redirected and that may be what is happening here. The natural attraction of the iron and the week magnetic field may be being used by the other magnets more for a redirect effect.

[Omnibus]

@ClaNZeR,

So, you think there’s an asymmetry between the attraction of the N pole of the rotor by the S pole of the stator (hindered by the bottom S pole of the rotor being repelled by the S of the stator) on the one hand and on the other hand, the repelling of the N pole of the rotor by the N pole of the stator (hindered by the bottom S pole of the rotor being attracted by the N of the stator), correct? If we only have one rotor and one stator magnet I don’t see how this can be accomplished. Don’t see it in the video either. Maybe after the whole rim is finished in the peculiar pattern we see in Mylow said asymmetry kicks in. Don’t see yet how exactly that may occur.

[PaulLowrance]

This degaussing nonsense only clogs the discussion. What is needed now is to confirm that the rotor spins unattended as is shown in the videos.

I disagree. It should be one of the most important discussions here because the people that go test mylow's machine should measure and calculate the energy removed from the PM's and energy put into rotating the entire machine for the duration of time to see if it's > COP 1.

Why is that so vitally important? Because if it's not > COP 1, then we don't want to be irresponsible by having thousands of people around the world getting all excited and start spending their hard earned money and time building this.

PL