New design working

[DIDIT]

Hey,
I'm new to this site and found out that this is the place to spread the news.  I have designed and tested a magnetic motor using standard neo's and will be producing a video shortly.  There are a lot of sceptics on this site and I will try to make everyone hapy with the demands they requested on other topics.  For example, glass table, full view with camera showing entire machine.  This will not be a problem.  Hopefully this will end the question if it's possible to create a motor with magnets alone.  For the record it's not a traditional wheel design.  This is going to blow your mind
Till later.

[TechStuf]

For example, glass table, full view with camera showing entire machine.

In which case, I'm already leaning toward a magnetic beam amplifier hidden off premises....

LOL


DIDIT, I hope it has enough power to pry that heavy, cast iron lid from off the melting pot, cause iff'n not,
TPTB might cannabalize the magnets off it to help keep the lid on even tighter.

[0c]

Most important things:

1) Credible witnesses
2) Replication
3) Independent analysis

(Videos can be faked)

All 3 of those things are still missing for the design I proposed and it has gone nowhere for over a year. Mylow has not been able to do any of those things either. In fact, there are no overunity devices listed in this forum that have been confirmed by all three. I think you will have better luck if you can meet these requirements.

[broli]

Any drawings or something to explain the concept behind it?

[ramset]

DIDIT

Personally, I  think your approach will be just fine to start

We could do with a little mind blowing these days [something positive amongst all the negative]

Thanks 

Chet