New Wheel Design

[Tracker]

Hey, check out this thread.. seem familiar? ... j/k 
http://www.overunity.com/index.php?topic=7134.0;topicseen

Hi 4Tesla,

Not funny  How can you compare some Newbie with Alexioco, a man that contributes so much to our community. Shame
Alex - Go for it, we are all wating, preparing our PVC pipes.

regards,

Tracker

[Alexioco]

Hi 4Tesla,

Not funny  How can you compare some Newbie with Alexioco, a man that contributes so much to our community. Shame
Alex - Go for it, we are all wating, preparing our PVC pipes.

regards,

Tracker

lol, thanks for the support, oh and I'm 19 by the way   

In a min, I'm going to go and buy some axle "stuff" again and then cut the levers and see what happens...


ta ta for now

Alex

[Alexioco]

ok I got the stuff, and it just so happend that its the exact size I need so whoooooo, I will now make the axle then cut the levers abit later...

Alex

[Alexioco]

Ok, right, I had to go back again and buy another dowel, which cost me £2, nevermind though, the axle is now done, 6 1cm. diameter dowels have been placed around a 1.cm dowel axle inside a 4cm tube. All that is left to do now (as I keep saying) is to cut the levers so they dont tough one another, and then I should be able to test (I hope) the nails that hold the weights in may cause me a problem, I'm hoping they dont, but if they do, then dont be surprised lol

Edit: I just gave the wheel a spin with the new axle in (without the weights) its looking quite good, of course, the levers dont lift because they hit one another, which is why I need to cut them, some levers will be slightly longer than others, but the weights should be all the same according to eachother... The sooner, I can test this, the sooner I can reveal it, like I say, (I have to stress this) I am not saying it will work or it wont work until I have tested this, but whatever the outcome, I think you will like the idea and maybe it can be worked on...

Alex

[AB Hammer]

Alex

For fine adjustment, larger tooth files then sandpaper are very handy. I also keep a fine wire tooth brush for cleaning out the files.