Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[jerseyboy17]

Does anyone know what the gauge of the wiring that's used in the construction of the Kapandze
coil arrangement. 

[nievesoliveras]

Community service.

[LtBolo]

@nievesoliveras

Where did that schematic come from, and what do you know about it?

[romerouk]

The above schematic (Kapanadze_3.jpg) is similar with what I have used on one of my replications and with good results.There are some minor problems with it but it works. I don't understand why nobody has replicated it yet... or at least someone should try then see if it works or not.Too many negative comments will switch our brains off. People not believing in OU should not look at sites like this.

[dllabarre]

The above schematic (Kapanadze_3.jpg) is similar with what I have used on one of my replications and with good results.There are some minor problems with it but it works. I don't understand why nobody has replicated it yet... or at least someone should try then see if it works or not.Too many negative comments will switch our brains off. People not believing in OU should not look at sites like this.

Hi RomeroUK

I'm working along a similar idea.

Can you tell me what TR1 and TR2 are used for?  Is it just to isolate the signal from the bottom of the circuit from the transistors on the top of the circuit?  Like isolation transformers do?

Is there a component I could buy or do I have to make them by hand?

Thank you,
DonL