Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[T-1000]

I think I see another diffence between Aidas/Arunas/Wesley's (AAW) configuration and Tiger's.

Namely, Tiger's configuration seems to use the bilfilar coil connected in bucking mode (back-to-back serial opposing) and AAW's configuration seems to use the bilfilar coil connected in serial reinforcing mode.

Correct, Tiger's device do not operate on preconditioning magnetic nuclear polarization with high frequency encapsulated in low frequency signal. It has opposite way - HV sharp peaks on single sine wave.

This is why your questions about Tiger's device get ignored - to avoid confusion between different devices.

[verpies]

This is why you questions about Tiger's device get ignored - to avoid confusion between different devices.

...however I never intended to ask you about Tiger's device.

You mentioned the low power transformer yourself, and you explicitly stated that you used this transformer in YOUR experiments, thus it must have been related to your device.

In our experiment we used low power transformer for 50Hz instead of generator

Hence, any question about this transformer was related to your device and not Tiger's.
Despite that, my question was ignored...

[T-1000]

You mentioned the low power transformer yourself, and you explicitly stated that you used this transformer in YOUR experiments, thus it must have been related to your device.

Sorry for confusion

The mains transformer used was 50Hz 220V AC with output 9V 0.75A.

[philm]

@philm
Please measure the capacitance of your 2 copper strips when they are not connected together.

I would be more then happy to measure the capacitance of the cooper strips; however, I already put it together and I am now unable to.

But, there is some good news. I still have yet to put the secondary windings on my other half of the yoke. So, I can easily make another copper strip on the CNC machine and measure the capacitance when they are not connected.

If I remember to do this, which I should be able to since I too am wondering what the capacitance is, then I will measure the capacitance of the copper strip before I start winding the secondary (and I will post some pictures of measurements of the yoke, also)

[philm]

Before I forget,

@T-1000 and/or @Wesley

When the device was running, was the device cool or cold to the touch?