Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[verpies]

What determines frequency of low frequency coil ? (above transistor)

I don't know.
I did not draw Tiger's schematic diagram.

[verpies]

The main resonant frequency from copper plates. You take resonant harmonics with highest amplitude from it and use for 50 turns coil tuning.

Wow!
In the AAATRS device the ratio between these frequencies is over 7600 and if you take the main resonant frequency from the copper plates (1.6Mhz) to calculate this ratio, then it comes out to over 32000

[grizli]

Wow!
In the AAATRS device the ratio between these frequencies is over 7600 and if you take the main resonant frequency from the copper plates (1.6Mhz) to calculate this ratio, then it comes out to over 32000

AAATRS?

what this stands for ?

[Jdo300]

Wow!
In the AAATRS device the ratio between these frequencies is over 7600 and if you take the main resonant frequency from the copper plates (1.6Mhz) to calculate this ratio, then it comes out to over 32000

At first, it sounds ridiculous that one could actually harmonically couple two frequencies with a ratio of 32000 difference, however, looking at the following post seems to show that that there are specific harmonics which show a particularly strong energy signature:

http://www.energeticforum.com/renewable-energy/5762-missing-fundamental-generator.html#post96365

Ironically enough, according to the harmonic charts shown in the post, harmonic 8,640 and 34,560 show huge magnitude peaks .

- Jason O

[verpies]

AAATRS?
what this stands for ?

Aidas, Arunas, Antanas, Tiger, Rostislav, Stivep
as listed on http://freeenergylt.narod2.ru/aidas/