Selfrunning Free Energy devices up to 5 KW from Tariel Kapanadze

[Grumage]

Hi Grumage

On your device is amplifying pulse or keep same voltage peak?

Hi zcsaba77,

I am sorry I don't quite understand your question, do you mean in Phase? Just to clarify, although I could not measure the input voltage P/P value, it can't be more than 8 V P/P  because the amplifier is only fed by a 16 V input. I spent a fruitless yesterday trying to improve the current output only to find I had destroyed the amp module.

On a different note has anyone looked into the loading of the Strange Russian transformer. I watched a Youtube vid where a guy kept on hanging Led's but there was no mention of how that reflected on the input side. The whole lot was being powered by a single AA battery.I ask because I am Ampless at the moment

Could we be so lucky that it did not reflect back? Probably not!

[Hoppy]

A good introduction to radiant energy is here:-
http://www.4shared.com/video/PvmfKu0T/Energy_From_The_Vacuum_Part_06.html

He also explains the gating of the Bloch wall as a generator of vacuum energy.

My understanding of Bedini's theory is that the Bloch wall is in effect a portal / gate for the entry of aetheric energy, not the generation of that energy. The Bloch wall acts as a an aetheric pump through  expansions and contractions caused by a pulsating electromagnetic field.

[a.king21]

My understanding of Bedini's theory is that the Bloch wall is in effect a portal / gate for the entry of aetheric energy, not the generation of that energy. The Bloch wall acts as a an aetheric pump through  expansions and contractions caused by a pulsating electromagnetic field.

Yes, my wording was clumsy.

[truesearch]

@Hoppy:


That reminds me again of the "Richard Clark" writings and diagrams referencing "Bloch wall" manipulation. See following picture.


truesearch

[zcsaba77]

Hi zcsaba77,

I am sorry I don't quite understand your question, do you mean in Phase? Just to clarify, although I could not measure the input voltage P/P value, it can't be more than 8 V P/P  because the amplifier is only fed by a 16 V input. I spent a fruitless yesterday trying to improve the current output only to find I had destroyed the amp module.

On a different note has anyone looked into the loading of the Strange Russian transformer. I watched a Youtube vid where a guy kept on hanging Led's but there was no mention of how that reflected on the input side. The whole lot was being powered by a single AA battery.I ask because I am Ampless at the moment

Could we be so lucky that it did not reflect back? Probably not!

Hi Grumage

I try put question else:
Your output signal is amplifying (ex: start from 8Vp/p and finish on 32Vp/p and send by spark gap over to load or next device) or sinusoid signal is keeping level(not raise, not fall), I see on your scope sinusoid signal this is input or output?

Because I playing with this:
http://www.sciences.univ-nantes.fr/sites/genevieve_tulloue/Elec/Transitoire/Condensateur1_flash.htm#
....and I saw if I switch in good time signal raise, but little bit later I can not raise signal more, keeping voltage peak to peak, my opinion (maybe is wrong theory) if I can not raise more, need send away power/voltage, and raise again from beginning.