Earth Electrical Energy Datalogging Experiments

[electricme]

@All
I just came across this web site on Tesla, a treasure trove of his work and information.

   http://www.tesla.hu/tesla/tesla.htm

I hadn't seen this site before, looks very interresting

**************************
OK what I'm going to post may trigger a memory with some readers, of a post I made 2-3months ago on the JT forum, I talking about my earth battery lightning a LED, I was very very excited about that, and somehow I did it, but don't quite know how as it was dark when I made the video.
It seems I had bumped the cliped together circuit and I had not been able to replicate my own LED being lit.
So tonight I'm posting a completly "NEW" situation here, I don't want any egg over my face, embarrassment does slow one down some.
I have checked, double checked and tripple checked this, it seems to be working of earth energy directly without any interference from any other source that I know of up to tonight.


I have just been able to very very dimly light a white LED off my EB.

This is the Round Earth Battery, I made a couple of months ago, showing all the steps I had done by photos I posted in the JT topic of Bills.

Before Bridge diode voltage was around .6v

I made a bridge diode, using 1N4007 single diodes, I have about 1.9volts, hmmmm.
I atatched the LED, it came on very very very low.

Then I accidentally touched the cathode, and the diode dimly brightened a little, still holding the cathode, I stood up, it brightened a little more.
So somehow I became an aerial for "air" energy, which is interracting with the EB.

Next I got about 5 meters of copper wire, and strung it around the corner, now the LED stays dimly lit without my finger on it. Now what will occur if I throw it up on top of the house roof, ha ha.

I took a series of photos of the scope before and after, there appears to be no noticeable difference to the waveforms.
If you look very close, right at the top of the wave, there is a very sharp peek, then right at the bottom, there is an opposite sharp peek.
This has been unchanged for 2 days now.

jim

1131 = DMM reading before LED lights 1.905v dc
1133 = DMM reading after LED lights 1.881v dc

1128 = current EB waveform today 19/07/2009     Queensland Australia
1129 = closeup of current waveform, the broad green wave is a heat related fault with the cro, the old B&W 511. It OK when cold.

[altrez]

@altrez,

I think I know what you are about with your EB idea.
I came across a web site and downloaded and printed some extremely interresting information, how to make the Earth Battery and a Capacitor plate battery.
I will do another search for it shortly and post the http address, it made seance to me, its almost a back to front EB, electrodes wise, but it seems to be able to put out voltage and current.
It needs more investigation in my humble opinion, but if it works as is stated, then this might be the one.

jim

Hey Jim

I think you know exactly what I am trying to do. And I am sure it can be done! Right now I am getting around .970 on my earth battery. I got some pictures of my scope to upload today. It still shows next to no wave form. However I did capture some juice in a small cap it was 1.4 volts in a small cap.

This tells me that the EB is in fact putting out real energy. I know everyone on here has already  seen that. But I needed to see it for my self

an unlimited supply of power in the 1-2volt range can produce some real power.

On and by the way I tested running a 350 watt inverter from a dedicated 1 v power supply and I got it to work. this is what I did:

1. Take 1.2 v power supply with  300 mA current
2. Increase voltage to 12v with JT
3. Charge 12 volt 7 amp hour battery "took around 30 hours"
4. Run inverter =)

It works! It wont work in real time yet. I just needed to see it to understand that it was possible. So really all we need is 1-2volts and 300mAs an we could work some magic.

Take Care

-Altrez

[altrez]

@All
I just came across this web site on Tesla, a treasure trove of his work and information.

   http://www.tesla.hu/tesla/tesla.htm

I hadn't seen this site before, looks very interresting

**************************
OK what I'm going to post may trigger a memory with some readers, of a post I made 2-3months ago on the JT forum, I talking about my earth battery lightning a LED, I was very very excited about that, and somehow I did it, but don't quite know how as it was dark when I made the video.
It seems I had bumped the cliped together circuit and I had not been able to replicate my own LED being lit.
So tonight I'm posting a completly "NEW" situation here, I don't want any egg over my face, embarrassment does slow one down some.
I have checked, double checked and tripple checked this, it seems to be working of earth energy directly without any interference from any other source that I know of up to tonight.


I have just been able to very very dimly light a white LED off my EB.

This is the Round Earth Battery, I made a couple of months ago, showing all the steps I had done by photos I posted in the JT topic of Bills.

Before Bridge diode voltage was around .6v

I made a bridge diode, using 1N4007 single diodes, I have about 1.9volts, hmmmm.
I atatched the LED, it came on very very very low.

Then I accidentally touched the cathode, and the diode dimly brightened a little, still holding the cathode, I stood up, it brightened a little more.
So somehow I became an aerial for "air" energy, which is interracting with the EB.

Next I got about 5 meters of copper wire, and strung it around the corner, now the LED stays dimly lit without my finger on it. Now what will occur if I throw it up on top of the house roof, ha ha.

I took a series of photos of the scope before and after, there appears to be no noticeable difference to the waveforms.
If you look very close, right at the top of the wave, there is a very sharp peek, then right at the bottom, there is an opposite sharp peek.
This has been unchanged for 2 days now.

jim

1131 = DMM reading before LED lights 1.905v dc
1133 = DMM reading after LED lights 1.881v dc

1128 = current EB waveform today 19/07/2009     Queensland Australia
1129 = closeup of current waveform, the broad green wave is a heat related fault with the cro, the old B&W 511. It OK when cold.

Nice work!

-Altrez

[Doug1]

That's Peppi's pages those have been around for a long time. It's not the complete collection but it is one of the largest collections you'll find on the net. I have never seen any single resource for everything tesla has had a hand in and or a patent for in one location. There seems to be one or two more that pop up every so often that are not in the lists. The guy was a work animal not big having a life or friends or family. If he couldn't coil it,make it spark or vibrate it was of no interest to him.
  On the other hand he would have never gotten half that work done if had other interests. I like to imagine he made the ultimate sacrifice for sake of humanity but it is more likely people in general just really pissed him off with the useless babble and self indulgence.
Babble, the other occupation when work is just to darn much like work.lol

[IotaYodi]

http://www.overunity.com/index.php?action=dlattach;topic=7769.0;attach=36035;image

This could be possibly a scalar wave.
“Scalar waves are produced when two electromagnetic waves of the same frequency are exactly out of phase (opposite to each other) and the amplitudes subtract and cancel or destroy each other. The result is not exactly an annihilation of magnetic fields but a transformation of energy back into a scalar wave. The scalar field has reverted back to a vacuum state of potentiality. Scalar waves can be created by wrapping electrical wires around a figure eight in the shape of a möbius coil. When an electric current flows through the wires in opposite directions, the opposing electromagnetic fields from the two wires cancel each other and create a scalar wave.”
The Nodes shown on the waveform may be where the 2 identical frequency's intersect. From what I see of the pic you do have 2 identical frequency's in opposite phase.
Stubblefield may have condensed or tuned these frequency's which may account for the glowing of the earth.