A validation of the UP-SIDE-DOWN phenomena

[tsl]

@EM
"1. find a magnetic frequency."

How do you do that? Based on what?

[hartiberlin]

Hmm,
so finding the magnetic frequency is involving a spectrum analyzer first
or can you find this on a scope via ripples frequencies on your 50/60 Hz lines
and zoom in with your scope and measure the frequency ?

2. How do you trim the coil wire to resonance,
when you alreay have wounded the coil ?

Does this trick with pulling one wire of the coil  up solve the problem ?

[hartiberlin]

So basically this is not free energy, as you extract the energy
from the radiating grid lines...
Hmm, what about tuning to 60 Hz  ?

Couldn´t this be done too with bigger sized coils and caps ?

[innovation_station]

well now ... 

why not tune to 7.8 and put the magnet in the correct place ...  seperated by air gap and a steel plate and turn the flux off and on .. or maybe let the coil do it 4 u 

or tune to 7.8 grab 1 volt and step it up ...

much like coil 202 i scrached my head on for soooo damm long ...

ist!

[wattsup]

@EM

I made another ring but again nothing and your directions are a little confusing for me to follow.

I would like to know if the ring wire in a single strand or multi-strand.

Maybe for your biggest loop, is it possible to give the complete build spec, ring wire type, awg, length, LED value, cap value. This may be simpler then for others to replicate.

Maybe one last question or request if I may. Can you do the same calculation with a ring that is only 2 1/4 turns like in the FTPU. lol

If the frequency is relative to the ring diameter as SM says, then maybe your calculation method has some relevance to this.