Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



HV- voltage multiplier circuit confirmation needed

Started by Steven Dufresne, December 03, 2009, 12:15:07 PM

Previous topic - Next topic

0 Members and 2 Guests are viewing this topic.

bolt

Quote from: gsmsslsb on July 09, 2010, 08:48:20 PM
As for insulation I am looking into potting the whole thing in parafin wax.
Melts at 45 - 60 degC I will just have to check what temp the components can handle then get the wax.
I am feeding with a 15000 volt neon transformer and have 19 stage CW cascade so taking peak to peak voltage I should be able to get over 300 KV.

Very hard to use a ladder over 100kv it will flash over everything and creep back over the diodes etc. Years ago i used clean engine oil it works fine. Gives about 3 times voltage rating before breakdown so if you had problems at say 50kv it will run to 150kv with the board submerged in oil. I used a tuppaware box filled with oil and put the lid on and used spark plug ht cables thru tiny holes in the lid far apart on the width.

  Better to add just a few stages to NST then finish off with a large tesla coil that what they are made for!