STEORN DEMO LIVE & STREAM in Dublin, December 15th, 10 AM

[k4zep]

Hi Gang,

Just testing a core a few min ago and I have a motor that runs on 1.000 VDC, 25-30 ma. ON ONE CORE.  Uploading video, will post location in a few min.

It has been a very good day and Ossie my friend has been a huge help in our continuing conversations!!!!!

Ben K4ZEP

[callanan]

Hi Gang,

Just testing a core a few min ago and I have a motor that runs on 1.000 VDC, 25-30 ma. ON ONE CORE.  Uploading video, will post location in a few min.

It has been a very good day and Ossie my friend has been a huge help in our continuing conversations!!!!!

Ben K4ZEP

WHOOOOHOOOOO!! Great work ol' buddy!!!

Ossie

[k4zep]

WHOOOOHOOOOO!! Great work ol' buddy!!!

Ossie

OK GANG,  check out:

http://www.youtube.com/watch?v=I3LUakks9U4

Actually it will run @ .900 VDC @ 12 ma.  DC pulses should be would be 130 ma but with the coil as an AC device, current drops WAY down.

Enjoy, Their ORBO will run on 1.5 VDC,.....well I proved it will run on .900 VDC, with only one coil,thery are the real thing as far as a motor goes!!!

Ben

[Groundloop]

Bruce,

I agree with Gyula. Use a Ferrite core in your pickup trigger coil.

You can also use some DC bias to the trigger coil as shown in
my drawing back on page 63 in this thread. I have built and tested
this circuit on my motor and it works very well. The motor is easy to
start because of the bias voltage. When the motor gets up to speed
then I just turn down the bias. The bias voltage on the trigger coil
is also a great RPM adjuster.

Alex.

[CLaNZeR]

OK GANG,  check out:

http://www.youtube.com/watch?v=I3LUakks9U4

Actually it will run @ .900 VDC @ 12 ma.  DC pulses should be would be 130 ma but with the coil as an AC device, current drops WAY down.

Enjoy, Their ORBO will run on 1.5 VDC,.....well I proved it will run on .900 VDC, with only one coil,thery are the real thing as far as a motor goes!!!

Ben

Nice one Ben

0v line looking like no BEMF.

Cheers

CLaNZeR