STEORN DEMO LIVE & STREAM in Dublin, December 15th, 10 AM

[captainpecan]

At least we learned a couple details during Seans attempt to avoid answering any difficult questions.  He said they are using just over an amp of current.  And he also said the average runtime on the reed switch orbo is 7 days.

If they are pushing over an amp of current, and only getting around 1000 rpms, something seems wrong.  I think something stinks in Dublin.... 

[penno64]

Morning All,

Where can I get a look at this last Steorn video ?

Regards, Penno

[infringer]

No kidding I did not see anything yet where is the video were others already able to see the final video already I haven't seen nothing...

[woopy]

Hi all

thank Ossie and Jean Louis Naudin i can understand better how it works

picture 1  a replication with 4coils of about 1 ohm resistance  = good results but you can see on the trace that the impulse voltage is higher than the generative voltage  = long run but no OU!!

¨picture 3, 4 and 5 = new setup with 4 coils each of about 5 ohms  = the trace shows a short impulse current about 1.2 volts and a strong 2.1 volt generative wave.  But i can not get the timing to INSERT the motor impulse IN the generation wave    any idea ??

THE TIMING  IS THE KEY (+ a lot of determination)

good night

Laurent

[Airstriker]

I think that's about all they could show you... in a way that doesn't reveal much about the technology. Note, that their company is not about showing anything, but to earn money selling "how to". But anyway... go to Dublin and do the tests yourself. I'm pretty sure that the multimeter test will actually show you what you want to see - I hope it OU But you are obviously right - as for a finall demo it was simply shitty ;]