Agentgates´s TPU setup with strange wavehill hump

[onthecuttingedge2005]

anybody with any knowledge would of dissected both, this is what an engineer does.

[otto]

Hello all,

@wings

no, Im not testing this coils here. I have "my program".

@gotoluc

I dont have a camera so its almost impossible for me to show you this effect in a video.

But I can describe you a little bit what I see:

when I pulse my coil I see really big kicks. I cant measure them with my scope because I would blow the last working scope probe I have.
As I have a "special signal" I see and can test that the particles are swirling around my TPU.

Then, when I lift 1 end of my TPU to 90° to my workbench I see that there are NO KICKS!!! Of course, no kicks, no particles are swirling around the TPU and then its clear that there is no light anymore.

Then, when I totally flip over my TPU I see again big kicks. But this kicks are totally different. And of course the particles are stopped and there is NO light. Again, I can test it without any problems.

So, Steven was right!!! Without any doubt!

@Marco

are you sure about your words?

Otto

[teslaalset]

@Otto, can you explain how you 'see' kicks without the use of an oscilloscope ?

@beboszek, your driving circuit has quite some similarities to mine.
I also use a IRF540 to drive the primary coil.
If I apply 1 KHz square wave, my results are indeed very simular to what your scope picture shows.
My coil looks very simular, only some differences in the wire thickness.
Mine is also 80 mm diameter, 70 mm height.

[otto]

Hello all,

@teslaalset

Im using my scope!! But its not connected!! The scope probe is near the TPU or 1 feet away and I see the signals without any problem.

In the past I have blown 5 scope probes and I dont want to blow my last  probe that I have.

Otto

[ronotte]

Hi Marco,

I enjoyed very much your video-clip

I do owe a similar, perhaps bigger 'store' of TPUs in various state of readiness, other cannibalized for parts, not speaking about coils, caduceus, spirals, Tesla stuff etc. I hope I will have time to setup something documenting the incredible efforts I did and I am still doing. I could setup a store or a museum (like many others). I am also almost sure I have been very near to a full success... 

Irrespective of his success that I really wish him, at least agentgates is 'doing something' which is different from...zero, I appreciate his commitment even if my personal opinion is different as in the past I already, like several others, have done a similar test for spherics design without showing significative results.


Roberto