Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Solid State Orbo System

Started by Groundloop, January 06, 2010, 12:21:24 PM

Previous topic - Next topic

0 Members and 15 Guests are viewing this topic.

Print
Go Down Pages 1 ... 74 75 76 77 78 ... 148
User actions

ramset

#375
March 02, 2010, 03:42:04 PM
Omega O
quote:
Clearly, most people don't know what COP is. It must be restricted to heat and heat only, nothing else.
---------------
Quite true ,however to state the profoundly obvious.

You could go "loopty luuu..........[hopefully where this is heading]

Just so everybody is happy! =:]

Chet
Whats for yah ne're go bye yah
Thanks Grandma

Bruce_TPU

#376
March 02, 2010, 07:51:30 PM
Pleasant Evening ALL,

Well, I have added my 5th Brooks output coil, located at the very bottom of the bottom toroid, in parallel with the other four....

First I tested it alone at:
1.045      V
70.3        R
0.01486   I
0.01552   P

Next I wired it in parallel, (you must test the leads, because if I put the leads on the wrong side and it cuts your power in half!) And the following is what happened:

3.15        V
33.1        R
0.09517   I
0.2998     P

This one coil BOOSTED TOTAL POWER (wattage) output by 61%   

One more Mr. Brooks to wire up and then time to really have some fun!

Cheers,

Bruce
http://www.energyfreedomreport.com
1.  Lindsay's Stack TPU Posted Picture.  All Wound CCW  Collectors three turns and HORIZONTAL, not vertical.

2.  3 Tube amps, sending three frequency's, each having two signals, one in-phase & one inverted 180 deg, opposing signals in each collector (via control wires). 

3.  Collector is Magnetic Loop Antenna, made of lamp chord wire, wound flat.  Inside loop is antenna, outside loop is for output.  First collector is tuned via tuned tank, to the fundamental.  Second collector is tuned tank to the second harmonic (component).  Third collector is tuned tank to the third harmonic (component)  Frequency is determined by taking the circumference frequency, reducing the size by .88 inches.  Divide this frequency by 1000, and you have your second harmonic.  Divide this by 2 and you have your fundamental.  Multiply that by 3 and you have your third harmonic component.  Tune the collectors to each of these.  Input the fundamental and two modulation frequencies, made to create replicas of the fundamental, second harmonic and the third.

4.  The three frequency's circulating in the collectors, both in phase and inverted, begin to create hundreds of thousands of created frequency's, via intermodulation, that subtract to the fundamental and its harmonics.  This is called "Catalyst".

5.  The three AC PURE sine signals, travel through the amplification stage, Nonlinear, producing the second harmonic and third.  (distortion)

6.  These signals then travel the control coils, are rectified by a full wave bridge, and then sent into the output outer loop as all positive pulsed DC.  This then becomes the output and "collects" the current.

P.S.  The Kicks are harmonic distortion with passive intermodulation.  Can't see it without a spectrum analyzer, normally unless trained to see it on a scope.

Bruce_TPU

#377
March 02, 2010, 08:54:31 PM
Hello ALL,

6th Brooks coil is now in place, and below are the stats!

Top and final Brooks coil by itself:

.719       V
71.3       R
0.01008  I
0.00724  P

Now, what happens when we connect this WEAK coil in parallel with the rest?  Hmm...

3.25         V
29.5         R
0.11017    I
0.35805    P

20% OVERALL INCREASE IN POWER!  Very Cool!
1.  Lindsay's Stack TPU Posted Picture.  All Wound CCW  Collectors three turns and HORIZONTAL, not vertical.

2.  3 Tube amps, sending three frequency's, each having two signals, one in-phase & one inverted 180 deg, opposing signals in each collector (via control wires). 

3.  Collector is Magnetic Loop Antenna, made of lamp chord wire, wound flat.  Inside loop is antenna, outside loop is for output.  First collector is tuned via tuned tank, to the fundamental.  Second collector is tuned tank to the second harmonic (component).  Third collector is tuned tank to the third harmonic (component)  Frequency is determined by taking the circumference frequency, reducing the size by .88 inches.  Divide this frequency by 1000, and you have your second harmonic.  Divide this by 2 and you have your fundamental.  Multiply that by 3 and you have your third harmonic component.  Tune the collectors to each of these.  Input the fundamental and two modulation frequencies, made to create replicas of the fundamental, second harmonic and the third.

4.  The three frequency's circulating in the collectors, both in phase and inverted, begin to create hundreds of thousands of created frequency's, via intermodulation, that subtract to the fundamental and its harmonics.  This is called "Catalyst".

5.  The three AC PURE sine signals, travel through the amplification stage, Nonlinear, producing the second harmonic and third.  (distortion)

6.  These signals then travel the control coils, are rectified by a full wave bridge, and then sent into the output outer loop as all positive pulsed DC.  This then becomes the output and "collects" the current.

P.S.  The Kicks are harmonic distortion with passive intermodulation.  Can't see it without a spectrum analyzer, normally unless trained to see it on a scope.

wings

#378
March 03, 2010, 04:28:37 AM
Quote from: teslaalset on March 02, 2010, 03:36:49 PM
Naudin has withdrawn his part 7 on COP of 8.1

news:

http://jnaudin.free.fr/2SGen/indexen.htm#ratio

l  = ((Vdem^2)*10000) / ((Vmag^2)*10000) = 13.8?

gravityblock

#379
March 03, 2010, 05:41:35 AM
Quote from: wings on March 03, 2010, 04:28:37 AM
news:

http://jnaudin.free.fr/2SGen/indexen.htm#ratio

l  = ((Vdem^2)*10000) / ((Vmag^2)*10000) = 13.8?

If you round it up, then it is 13.8.  After reading the reference materials provided by Naudin on the magnetization-demagnetization of the core and the way this experiment is performed, I will have to agree the 13.8 is a good indicator of COP.  Next step is to close the loop.  ;D

GB
Insanity is doing the same thing over and over again, and expecting a different result.

God will confuse the wise with the simplest things of this world.  He will catch the wise in their own craftiness.
Print
Go Up Pages 1 ... 74 75 76 77 78 ... 148
User actions