Muammer Yildiz Magnet Motor

[hartiberlin]

Report of the presentation of the Yildiz magnet motor at 20-04, '10 was held at Delft University.

Thanks to Dick Korf for the following explanation.

Dear friends,

Yes, it was a very interesting demonstration this afternoon.

There were about 40 to 50 attendees.  The demonstration was by Coen Vermeeren of the TU Delft organized.

By a blow with a plastic hammer on a projection unit started and ran right around 2000 rpm.

By using a glove to the axis (try) to stop (to boost resistance) was rated well back but still developed a good couple.

The principle is based mainly on permanent magnet technology whereby magnets consisted neodyn is a very powerful magnetic material and also is maintained over time.

On the shaft is mounted a fan that causes a decent airflow.



How much energy could supply the device is not listed but Han Vriezen, long time colleague who is involved, requires 300 to 400 watts.

Compared to a weight of 35kg in 1 second the meter is lifted!

After the demonstration (approx. half hours) it has removed all exterior mainly consisted of magnets in aluminum trays were deployed / installed.

Overall, it gave it a fairly simple image where there is no magnetic coils came to pass.

Unfortunately, the rotor is not removed. (A patent is still pending).

Anyway it was clear that energy was supplied without energy was supplied and this is incredibly unique because it  scientifically just may. Scientifically just Can not. Since it is known, however, be virtually nothing left.

Zero or Free Energy.  Yes, everything should still have time!?

The presentation was led by Duarte, a member of the TU Eindhoven where Han weather cooperates closely.



Last Saturday, the unit demonstrated in Germany where there are 3 professors were present along with Han and Duarte.

There too it was convinced that here there was zero point energy!

The next step is to obtain funding for further optimization and perhaps further upscaling.

I have a very nice touch with the inventor (unfortunately only speak Turkish) and his pal, a Turkish lawyer from Germany, has never been offered that I knew possible funding.

My goal in this is mainly to further development in the Netherlands to maintain and therefore should take place here and get more grip on the further development.

You never know where all this is good for.

I got the impression that there was not opposed.

Further contacts should show this.

Weight 48kg, diameter ca.300mm.

The last picture shows the magnet holders disassembled.

Warm regards,Dick.

[zerotensor]

I did a spectral analysis of the audio from the demonstration.  It appears that the machine slows down a little bit.  Here is a portion of the spectrogram:

[luishan]

Check it out.
There is a download link of detail diagram information of the motor.

http://www.youtube.com/watch?v=EvWxe_RRo8k

[giantkiller]

Only part way disassembled. The bottom section is never opened. That is also where the 'Bang' switch is. The bottom section is big enough for 1200mah batteries. Considering how long it rang everything is in the ball park.

Let us see the bottom side. We are assumming symmetry in all sections. But never shown.

[Cherryman]

Check it out.
There is a download link of detail diagram information of the motor.

http://www.youtube.com/watch?v=EvWxe_RRo8k

http://www.overunity.de/index.php?action=downloads;sa=downfile&id=42