Self running coil?

[gotoluc]

Here it is as a jpg and pdf
Let me know if it is ok.
Harry

Excellent work Harry

Thank you very much for the great job

I'm looking it over and will let you know of any add ons or changes.

Luc

[gotoluc]

Okay Harry,

here is the add on:

Add (With magnet aprox. 1/8" air gap) and (With magnet aprox. 1/16" air gap) See attached

And like Mags says, both coil sides start and end the same way. This maybe the most important point as so far this is the only coil that works.

Thanks

Luc

[mrock]

Edited & Compacted

[NextGen67]

Okay Harry,

here is the add on:

Add (With magnet aprox. 1/8" air gap) and (With magnet aprox. 1/16" air gap) See attached

And like Mags says, both coil sides start and end the same way. This maybe the most important point as so far this is the only coil that works.

Thanks

Luc

And the 24 mm should be .24 mm? (actually .255 including dielectric layer?).

@Luc, could you maybe find out the fabric/type of the core, and maybe give a 2 digit value for the coil resistance e.g: 6.9x Ohm.

It's a very clean and simple circuit !

--
NextGen67

[NextGen67]

@Luc,

You mention in the video that while the Cap is charging, you constantly need to re-adjust the frequency of the generator slightly. That means the Cap is influencing the coil behavior... Is there a way to collect the energy in the Cap, but exclude the cap from the from the rest of the circuit? Or just try to place the cap (or another one) at a different place in the circuit and by such avoid any possible leaking at all ?  Maybe a simple diode could allow a one way only energy direction to the Cap.

--
NextGen67