Text only | Text with Images

Overunity.com Archives

Mechanical free energy devices => mechanic => Topic started by: gammarayburst on August 09, 2011, 06:21:41 PM

Title: LaFonte Group Rotary Pseudo Solid Fanner Motor Generator Animation and Drawing
Post by: gammarayburst on August 09, 2011, 06:21:41 PM
Video link > http://www.youtube.com/watch?v=sOBrpbvxBwk
Also see attached drawing.
Both aspects of operation proven in testing and shown on video.
Thanks Ray,
Butch
Title: Re: LaFonte Group Rotary Pseudo Solid Fanner Motor Generator Animation and Drawing
Post by: gammarayburst on August 10, 2011, 12:54:00 AM
The drawing and animation is a Rotary Pseudo Solid Fanner principle motor/generator.
It's super simple. When the bar ends are in line with the magnets the bars seperate due to the fanner principle.
When the bars are 90 degrees to the magnet poles the bars are pulled into the rotor and it becomes a Pseudo Solid rotor.
The bars do not seperate in the first step until the magnets poles are half way across the width of the bar ends.
There is a small air gap between the magnets and the rotor so the Fanner effect can work.
The magnet poles have a radius to follow the round rotor and keep the air gap constant.
Thanks Ray,
Butch
Title: Big improvement in bar design, pull inward increased
Post by: gammarayburst on August 10, 2011, 02:40:07 PM
See attached drawing
Title: Re: LaFonte Group Rotary Pseudo Solid Fanner Motor Generator Animation and Drawing
Post by: broli on August 10, 2011, 04:15:55 PM
Good concept.
Title: This may be an even better bar design?
Post by: gammarayburst on August 11, 2011, 12:06:09 PM
See attached drawing,
Thanks Ray,
Butch
Title: Note about operation
Post by: gammarayburst on August 11, 2011, 12:16:53 PM
"The overunity work comes from the work done by the bars being pulled back into the the rotor. The fanner effect in the first stage that seperates the bars is not a this time a source of work. This first stage is a break even operation.
Butch"
Text only | Text with Images