Hello,First test of MADACELL.
I'ts the first real Hydrogen cell made in sLOVEnia. All materials are from slovenian manufacturers. The design and all of it's components (CAD) is made in slovenia (by me and my friend).
This run is the first of this CELL.
Power consumption per liter per minute is about a 200W.
The regulator, electronics and aplication (VB2010) is also made by me in sLOVEnia.
The CELL is made of stainless steel, 316L with the elecrolite surface of about 4 square meters. In this first run we've had connected only 3 (2 connected - 1 neutral) of 35 plates. Electrolite is 3% KOH.
Measurement specifications of aplication are:
- Gas flow per minute
- Electric current
- Voltage
- Temperature of GAS
The PWM controll can regulatulate Current and Frequency
All measuring equipment is validated by the certificated laboratories.
Problem: The torch for cutting was designed for gas flow of 0.2lrt/min, therefore the flame was so weak. Our bad :(
Next test will be in about a month(or earlier we hope) with input of minimum 1kW DC. Then we'll measure the average gas flow output per minute in dependence of power. With new torch, aswell.
This will be the real test :)
http://www.youtube.com/watch?v=E0LQ5gAq8uQ
Best Regards, M&D