Print Page - Oil and water

Title: Oil and water
Post by: Gabriele on March 04, 2013, 03:45:01 PM

Does it work?

Title: Re: Oil and water
Post by: Gabriele on March 04, 2013, 03:49:50 PM

Then we move the apparatus up again and the springs reset the divisory wall

Title: Re: Oil and water
Post by: Gabriele on March 04, 2013, 04:37:24 PM

ok,seems not

Title: Re: Oil and water
Post by: Airstriker on March 05, 2013, 01:50:54 AM

If you could say a bit more it wouls be nice. Thx

Title: Re: Oil and water
Post by: Gabriele on March 05, 2013, 10:02:36 AM

The left side of the piston is 2 times of the right side so pression is equal. I we move down apparatus pression on both sides remain the same. But if we move down the apparatus,pression on the divisory wall doesn't change so no energy gained. If we had water on the left side the wall would move. But to rise the apparatus again we would have need energy. I understand it doesn't work,sorry...

Title: Re: Oil and water
Post by: Gabriele on March 07, 2013, 03:31:58 PM

This apparatus should provide an orizzontal thurst to the right... comments? Inside cilinders there is compressed air that provides 6gr. Measures are 12 cm for oil cilinder 6cm for water can...

Title: Re: Oil and water
Post by: Gabriele on March 10, 2013, 03:40:24 PM

Read description on the figure

Title: Re: Oil and water
Post by: Gabriele on March 10, 2013, 04:43:42 PM

Can someone confirm this fact?

Title: Re: Oil and water
Post by: Gabriele on March 10, 2013, 05:01:32 PM

We keep de divisory wall vertical and the ball has to roll right,cause the baricenter is on the right... right?

Title: Re: Oil and water
Post by: Gabriele on March 11, 2013, 12:38:34 PM

I would like to hear a comment about the baloon. Weight on the circunference on the right is heavier than left...it must roll!

Title: Re: Oil and water
Post by: Gabriele on March 11, 2013, 02:24:10 PM

This silence. Have I to supponce I have reach the Truth?

http://www.youtube.com/watch?v=vBecM3CQVD8

Title: Re: Oil and water
Post by: Gabriele on March 11, 2013, 04:58:33 PM

Seems she rounds to the other side...

Title: Re: Oil and water
Post by: joint on March 12, 2013, 04:07:51 PM

yea it will go to the side but that it

Title: Re: Oil and water
Post by: dieter on February 07, 2014, 06:49:34 PM

I still don't understand the diagram. Is the middle wall supposed to remain vertical when it's rolling? Why is the water side not full?

Title: Re: Oil and water
Post by: Gabriele on February 08, 2014, 07:39:52 AM

Don't worry. Doesn't work.

Overunity.com Archives

Energy from Natural Resources => Gravity powered devices => Topic started by: Gabriele on March 04, 2013, 03:45:01 PM