https://www.youtube.com/watch?v=n4YD8Nvyfa4 (https://www.youtube.com/watch?v=n4YD8Nvyfa4)
By pairing 2 magnets inside a coil. 1 neo and 1 alinco magnet.
He can detach a keeper bar with a small pulse. I'm not sure it
it will likewise attract the keeper bar.
But this could apply to the Bedini permanent magnet motor
where the rotor is attracted to the magnet for free but then must skip past the magnet. If this concept could be applied to skip past the magnet then you
would already have the motor function.....
If this was used to deflect the arms of the wheel in the following gravity wheel arm it should generate more power than it uses. But at least it should make a much more
efficient motor.
https://www.youtube.com/watch?v=n4YD8Nvyfa4 (https://www.youtube.com/watch?v=n4YD8Nvyfa4)
Norman
I tried building this motor and discovered that saturation caused the ferrite keepers to become permanently magnetized after a short time span. I theorized that increasing the permeability of the keepers might help, but I didn't feel it was worthwhile enough to even try.