I'm in the process of experimenting with running my electric plant on water like this guy does https://www.youtube.com/watch?v=0B0wPUmZB3U&t=970s&ab_channel=HiddenTechnology but can anyone understand why my cables and rods with plates get hot after half minute when I have to cancel before the plastic melts. I use distilled water and also tried reducing with HH+ powder just that it bubbles but it still gets hot?
My long term study was the car and riding lawnmower conversion so as engine ran on electrolysis hydrogen" AT" spark plug chamber, along with water vapor pressure generated. This was the 2008 time period S1R9A9M9 system in Georgia, with water in original carburetor. On the Briggs 18HP, the 12 magnets alternator ran the circuit on 10 amps after battery was completely disconnected. (it was to be inferred as a self running engine) Website shut down. I copied tech data before that. Some other data on Internet, along with Nathren's 2 You Tube videos still there about mower engine. He also had earlier converted V8 1978 El Camino car, that tooled around town until locked up in garage- that used the green colored,Power on Board 400W 12vdc to 110vAC Inverter box. My own project was divided into 6 sections. Now 5th, finalizing the special required, ISOLATED hand made power supply needed for a BRIGGS 12HP + zero ohms resistance spark plug, for bench test. Questions?
Study this