anyone care to talk about amps please do so here
i am and have been serching for amps ;)
verry simple hifi low wattage amps tubes are perfered (less hassel and more forgiveing ;)
so there is NO fast switching square waves or any of that shit in a tpu
it is like a violin just make it sing the tpu is a musicial insterment
the way i see it right now is that the amp should be able to be powered by an external 9v battery ot mains with tubes
also i think the amp should always be powered by a battery it will make it easyer to control it
ist
lookie what i just found :o
http://www.freepatentsonline.com/5252931.html
kinda sounds like a triode style amp done with transistors hummmmm
is
just finding amps that may work for our appclation
http://www.amplifier.cd/Verstaerker/Amplifier_Gain1000/Amplifier_1000.htm
look at this .....
http://kk5dr.com/ampbuilders.htm
hummm.....
:)
well it sounds like the push and pull amp in the above paper will do the job just fine it shows 2 triode tubes in the schem and not much else so with 1 single dubble triode tube like the 1 i have i could build a push and pull amp with ;D
so im asking anyone that knows about tubes to help me out a bit as how i would build the rest of this simple amp
there is not much to it but this is where my skills are weak and well i will build it if i can
also still looking for other amps cuz im sure it can be done with almost any amp but it must not distort
in the push pull amp i posted above its neat how only the odd harmonics come through eh? hummmm ie 1st 3rd 5th etc
ist
well i think some or maybe most of you know this but if not i will say it now
the 3 freq generators and the amp are only run for the first few seconds {like the starter on your car engine} that is all
only used to start the coil operation because the coil becomes its own amp ;D
and its own supply so how can we do this hummm....
it was advised that we try a 3-4w amp for the input and also build a big ring
is
hey guys dont you think the tpu is a magnetic regenerative feedback amp?
hummmm.....
ist
hey why do we need a magnet?!?!?!?!?!?!? lol!!!
;D
hummmm.....
so when we place a magnet on our balum well the balum is a freoite ring so the flux from the permenant magnet will enter the feroitte ring and when we send our amped waves into our balum and the coil starts to hetrodyne rotate and vibrate that action or motion will contuinaly force the flux from the pernment magnet in and out of the balum and each time it enters back in it is greater than the last but this is only a guess i have not tested this but it makes sence
i was also gonna say that if the balums are wound opsite dirrections to the collector it would be like we would have a dubble hetrodyine a small round sphere in the center spinning 1 way and a larger sphere from the collector/control ring spinning the other way that would give the gyroscopic effect seen in the videos
no?
ist
well
i noticed this a wile ago but did not know how i would post it
so here it goes in my last post i mention about a dubble hetrodyne with the coils inner and outter well in playing with NCH TONE GENERATOR when i put my 3rd freq in to the mhz what happins with my wave !?!?!?!?!?!
well it is a hetrodyne to start with but i put my 3rd freq at around 1.4mhz-2.4mhz range it becomes a dubble hetrodyne wave i have seen this sooo..... it is neat and like i said i didnt know how to post it well i will make a vid of this too so you all can see i have forgoten the freqs i used exactly but i will find them agin ;) and post them here with the vid of the dubble hetrodyne wave 1 inside the other
ist
here is a picture of my amp i will be useing for testing my coil