I was going to try to build a simple Pulse Motor like this one to start with.
http://www.youtube.com/watch?v=8JliEeEKjUI
I was just wondering if for all the magnets the NORTH side goes out.
Or if it was North,South ,North ,South like in Nastranda2000 diagram I seen in one of the other threads in this forum?
This is how I winded my motor coil.
http://www.theverylastpageoftheinternet.com/howto/windingcoils.htm
Would the pickup coils be done the same way?
And would I still use a bolt or just wind the coil on an empty spool?
The parts I have so far are a TIP120 Transponder and a INT4742a 12 volt Diode. Diode is for after I do my pickup coil.
I was going to power it with a 12 v battery.
Are they the right parts?
I'm still waiting on my reed switch and some 1/4 inch magnets I bought off line.
I was going to try to mount eight magnets on a old hard drive I have.I seen a video like that on youtube to.
Or should I just use the four magnets?
If anyone could please help me out I would appreciate it ;)
Thank You..
@slayer007,
May I suggest moving over to this thread?
http://www.overunity.com/index.php/topic,4034.0/topicseen.html
Groundloop.
Thanks for the reply Goundloop.
But that thread didn't help me out to much.
Was still wondering about my magnet placement and the pickup coil.
But Thank You.
Quote from: slayer007 on February 01, 2008, 06:28:13 PM
Thanks for the reply Goundloop.
But that thread didn't help me out to much.
Was still wondering about my magnet placement and the pickup coil.
But Thank You.
@Slayer try this thread : http://www.overunity.com/index.php/topic,3318.0/topicseen.html
Cheers from The Toad Who Hops :)
Quote from: slayer007 on February 01, 2008, 05:23:39 PM
I was going to try to build a simple Pulse Motor like this one to start with.
http://www.youtube.com/watch?v=8JliEeEKjUI
I don't know about this item since I have trouble with videos, but you will find this good:
http://www.free-energy-info.co.uk/Chapter2.pdf
and do some browsing here:
http://www.free-energy-info.co.uk/
Also, the minatowheel group on YahooGroups is focussed on this:
http://tech.groups.yahoo.com/group/minatowheel/
Thank you
Some good reading.I have a lot to learn but that helped out a lot.
Thank You.
Well I have my motor running.
I did a bifilar coil the outputs about 7.5 volts after it goes thru the rectifier.
I wanted to add another coil or two.I added one more coil it gets about 7.5 volts to.
But I'm not sure how to hook them up to I can get 15 volts.
I tried a few differant ways but I can only get it up to about 7.8 volts I was hoping to double that.
If anyone has any ideas how to hook them up parallel so I could double my voltage please let me know.