1:
take 1 wimhurst machine.
2:
place a horseshoe magnet, over its 2 wheels.
so that the horseshoe magnets magnetic field,
passes THROUGH the 2 spinning wheels.
3:
wrap a wire coil,
around the horseshoe magnet.
4:
electrify the wire coil,
with high frequency AC electricity.
5:
the high frequency AC electricity,
passes through the wire coil,
through the horseshoe magnets magnetic field,
and into the 2 spinning wimhurst wheels.
6:
the high frequency electricity,
EXCITES the polarities, that are stored in the wimhurst wheels.
creating MUCH more electricity, than it took to power the whole thing.
(also creating much more voltage/amperage, than any normal wimhurst machine.)
this "O-W-M" device (can anyone say OWN and PWN?).......
unlike an overunity torroid.........
does not need a primary coil, with vulnerable wire-insulation.
or an expensive steel loop, to efficiently conduct flux.
or a power source, to power a primary coil.
(the wimhurst machine, is obviously its OWN/PWN power source)
this "O-W-M" devices output,
can likely even be used,
to power the horseshoe magnet coils!
unlike an overunity torroid,
for which powering the primary and kickers with the same output,
seems to be a no-no.
sound good... the polarity of the horse shoe need to change ?
meannng it needs to pass its own magnetic strength with each pulse?
i would think that the polarities stored in the wimhurst wheels,
just needs to be excited,
by the high frequency electricity.
anything else can be screwed around with, to your hearts desire.