Overunity.com Archives

Availbale Products, Material- and Service suppliers => Do It Yourself => Topic started by: magpie on April 22, 2009, 11:48:57 PM

Title: How do you build a resonating crystal circuit?
Post by: magpie on April 22, 2009, 11:48:57 PM
Hi there,

I need information on how to build a resonating crystal circuit. I want to put a specific frequency into a coil using a crystal instead of a function generator (I am not try to build a crystal receiver). The difference here, also, is that instead of sending a signal into an antenna (a single wire), I want to feed the signal into a coil, which obviously needs to be connected at both ends so that it i will be like a normal electromagnetic coil, except with a specific signal input . I am trying to make this specific experiment as simple as possible so that replication of the test setup is possible without a function generator.
Apologies for the simplistic explanation, I have little knowledge of electrical engineering but am trying to learn as quickly as possible.
Could anyone give or direct me towards straightforward information on a simple crystal circuit?

Thankyou :).
Title: Re: How do you build a resonating crystal circuit?
Post by: Groundloop on April 23, 2009, 02:37:35 AM
@magpie,

Look here: http://www.northcountryradio.com/PDFs/column007.pdf

This document describes various crystal oscillators very well.

May I ask what frequency you want to use?

Regards,
Groundloop
Title: Re: How do you build a resonating crystal circuit?
Post by: Nabo00o on May 08, 2009, 07:39:58 AM
Hmm, I don't know exactly what you want with the crystal, but is it magnetic resonance you had in your mind? ;)
I know for certain that you could do some cool things with this circuit if you fed it with a signal.
Title: Re: How do you build a resonating crystal circuit?
Post by: magpie on May 08, 2009, 12:39:58 PM
Quote from: Groundloop on April 23, 2009, 02:37:35 AM
@magpie,

Look here: http://www.northcountryradio.com/PDFs/column007.pdf

This document describes various crystal oscillators very well.

May I ask what frequency you want to use?

Regards,
Groundloop

Thanks for the link Groundloop. Ok, in the spirit of open source and keeping no secrets, here's what I want to do: I plan to connect 2 seperate crystal circuits to the 2 coils of a Rodin Coil. With the Rodin coil, the two seperate coils are supposed to be harmonized using sine waves. If you do some tests on the Rodin coil you will see that the 2 coils do indeed interact to produce different effects. I want to put in a different frequency in each coil to set up a harmonic resonance, there's some interesting information to do with Leedskalnin that comes in to play here, I'll let you know when I've built the circuits and done some tests.
In the mean time though, I need to find a chart or table that tells me what frequency (in Hertz) certain notes of a musical scale are, does anyone know where I could find one? This will allow me to get the correct crystals.
Also, I'm not quite sure what the waveform output of the circuits shown in the link are, I'm looking for sine wave ouput, is there perhaps a very simple circuit out that I could build to get a crystal oscillating and connected to both ends of each coil? When I say both ends I mean that I am not connecting the circuit like an antenna (to one wire), I will be "shorting" it like a regular coil, connecting power to both ends.
Thanks.
Title: Re: How do you build a resonating crystal circuit?
Post by: magpie on May 08, 2009, 12:42:08 PM
Quote from: Nabo00o on May 08, 2009, 07:39:58 AM
Hmm, I don't know exactly what you want with the crystal, but is it magnetic resonance you had in your mind? ;)
I know for certain that you could do some cool things with this circuit if you fed it with a signal.

Magnetic resonance? Possibly... Could you explain further? Do you know of a circuit that I could build?
Thanks.
Title: Re: How do you build a resonating crystal circuit?
Post by: Nabo00o on May 08, 2009, 01:03:10 PM
Oh sorry I was getting ahead of myself ;D Just thought for a minute that you were doing the same thing I was doing :D

About the crystals, you should just search for one at an Internet store, I don't thinks its that easy to make on your own, except if you happen to have a quartz crystal deposit somewhere near you  :D
Also, if you come from Scandinavia, England or some other place close, you get what you need from this site:
https://www1.elfa.se/elfa/index.html (https://www1.elfa.se/elfa/index.html)

Edit: It seems like they are selling all over the world now.
Title: Re: Solar panels
Post by: solarinstallation on December 17, 2010, 08:58:52 AM

Mohr Power Solar, Inc., is an established design, service, sales and installation solar contractor, specializing in solar electricity, solar pool / SPA heating, solar hot water heating systems for residential, commercial and industrial applications.

Mohr power Solar, Inc., was founded in 1982 to promote the public awareness and supply a “ Clean Environmentally Safe Energy ” to the Los Angeles, Orange, Riverside and San Bernardino counties. In addition, our company offers products, information and expertise to our customers nationwide.

Mohr Power Solar, Inc., has performed more services and has one of the largest customer base of satisfied solar energy installation customers. Mohr Power is the first solar service and repair company to service 165,000 systems for all manufacturers.

Mohr Power is the first to have a customer base of over 35,000 solar energy installation customers.





http://mohrpower.com
Title: Re: How do you build a resonating crystal circuit?
Post by: IotaYodi on December 17, 2010, 09:25:21 AM
http://www.deepsonic.ch/deep/freeload/audio_frequency_chart.pdf