Bob Teal - Missing interview finally surfaces after decades of searching

[klamathpro]

anyone going to replicate this and share?

I'm surprised no one has tried replcating this.  That motor in the video is putting out more than the equivalent 8 watts input.  But why is everyone so bent on trying to get OU on one invention alone? I said it before and I'll say it again, OU will be acheived when someone puts two or more technologies together so that one technology fills in the gap where the other is lacking. Why hasn't anyone applied this to the Newman or Bedini motor? Yet?

Why to this day, hasn't anyone shown on video the effects of hooking up a generator to the out put of these motors?  Why?  It makes no sense to go through all that experimenting and not follow through with solid results.  That Linderman device that those boys put together is producing enough horsepower and RPM to run an alternator as-is, and they already have a pully right on it!  Just put a freakin' car alternator right next to it and connect it 1:1 with a belt!  I get so frustrated when inventors don't follow through. 

That's it, I'm going to do it myself if I have to.  I've already built a successful miniature newman motor but I'm not posting results until I find OU by combining these technologies and putting a generator on the other end and show more watts out than in.

[armagdn03]

Bravo more replications! wish I could go about doing this as well, but I have alot on my table. I do wonder why there are coments made about no CEMF and no induction? Obviously if he has a coil there is induction (doesnt seem to be mobius or bifillar) and CEMF which drives the piston in the other direction. im confused.

[klamathpro]

Bravo more replications! wish I could go about doing this as well, but I have alot on my table. I do wonder why there are coments made about no CEMF and no induction? Obviously if he has a coil there is induction (doesnt seem to be mobius or bifillar) and CEMF which drives the piston in the other direction. im confused.

I don't know either.  Perhaps because there doesn't seem to be a magnet in that particular model so no CEMF???  I don't know. If you look at the cracked open rotor, they shaved the iron off the sides of the armature, but where's the magnet??  It seems to only work by eletro magnetism attracting the dead steel armature.  I really can't say without testing this myself, but the fact that there is no increase in current under load is what gets me.  With a lot more windings added to this design (like a Newman motor) the thing could operate on higher voltages but much lower currents.  According to Newman's theories, the more windings, the less overall input watts for the same output HP.  I say, with both technologies put together, OU is possible.  I'll have to try it myself.