Lunke Generators

[Lunkster]

Delete from forum

[Lunkster]

Hello All;

I started working with FE in 1969 to design magnetic motors using
unique designs I can up with.  It has only been the last few years
my interest has changed to generators. 
When using FE generators the need for OU motors is less. 
We can use all of our current low efficient electrical products
when we have an OU generator.


This means people only have to purchase one generator instead
of several products to begin with.
When I design devices, I try to look at ways that have not been
researched yet.  This means I have to come up with new technologies.
For motor designs, I have developed the following technologies.
One    "Flow through technology"
Two    "Three layer electromechanical movement"
Three  "Permanent magnet chain reaction"
For generator designs, I have used the following technologies.
One   "Indirect induction"
Two   "Permanent magnet chain reaction"
Three "Output coil rerouting"

I have a few generator circuits on this forum.
Most of my designs are in the four books I have written
And sold on Amazon.com along with other places.

The generator "Motionless Switching Magnetosphere Electric Generator"
was my best design because if uses one electromagnet to reroute the
flux paths of 128 or more permanent magnets.

Now this latest generator could be even greater than that generator.
In theory, the main function of the generator does not need any
Power if you toggle the two switches by hand.  If you do not want to
switch the switches by hand, the control circuit
to drive the two switches would be minimal in a power system.
I will only show one drawing of the latest generator here because
You can easily find the other ones, most on this forum.

The latest generator design called "Lunke Free Energy Generator" functions as follows:
It is like a three post transformer with the following differences.
The middle leg is a permanent magnet.
The other two legs are output coils.
The output coils alternate the way they are configured in the circuit
in order to reroute the flux flow in the generator.

It is commonly known that the larger the load on a generator,  more input power
is needed to operate the generator at the same output voltage.
So by shorting one output coil on both sides of the coil will produce
a maximum load on that output coil.  Since the flux from the permanent
magnet has a second route it can take, it takes that route that moves
the flux through the other output coil.  The change in flux flow is then
turned into electrical power in the generator.  The switches in the generator are now switched
and now the other output coil is shorted at both sides, causing the flux to change it's
route through the other output coil that is not shorted.

See the drawing for a better understanding of the operation.

These simple circuits can be duplicated in a system.
The electrical energy to cause the switching is minimal.
This is theory that I would like to see replicated over and over again.

Jay Lunke known as Lunkster

[skybiker63]

 8)Nice concept, gratulation