Magluvins Magnet Motor MMM Being released for open source developement.

[Magluvin]

Here is my new setup in 3d done in Cinema 4D.  I have pics of the real deal as shown, I just have to dig out my memory cards from the move. I can take some fresh pics, but I dont have the stator stands mounted, and havnt unpacked them yet.
Will get to it later today. 
Mags

[Magluvin]

Doh!  Ok mem card is here.  =]

Mags

[Magluvin]

The plexi rotor is 10 in. dia.  The pvc ring makes mags interchangeable with the rotor, of which these mags were funky, as in, they are not magnetized at center. I fiddled and fiddled, extracting them and rotating them to make it right, but I need to get new ones. This created a big imbalance. Some were way off and some were pretty good.
They were on sale but still cost quite a bit. N52  3/4 x 3/8 with so called black nickle coating. The stator mags were good, and if I had bought more of them they would have been excellent for the rotor also. But I only bought enough for each purpose. Im still shopping and questioning the distributors as to accuracy of flux bubbles. They all think im nuts. 
Ill do a vid on them as to how bad they really are. And I bet this is a concern for all magnet motors and people not realizing the problem. I should have listened to OC when he said go small.
Mags

[JWG]

Hello Mags,

Any progress beyond this? Are you posting on another forum?

Cheers,


jwg