New permanent magnet motor on youtube from Roobert33

[CLaNZeR]

@CLaNZeR,

Good job, mate. Wonder what you think about the bottom lever w/ magnet? Looking forward to seeing this darn thing spinning and spinning and spinning ... All the best for the New Year, a lot of health and successful experiments.

That goes also to everybody else: Happy New 2011 Year.

Hi Omni

Have commented on the bottom magnet over on the thread I posted above.

Have a great New Year that end and lets hope some new claims come along that are more detailed and bring us closer to something.

Last video for 2010

http://www.youtube.com/watch?v=ArzqkXmDFVo

I am off out to enjoy a smack up meal with family and maybe a few drinks to see the New Year in !

Happy New Year to all the usual FE/OU community guys.

Cya in 2011

Cheers

Sean.

[maw2432]

I've given the 4 stator idea some though. Each stator should be able to be lifted by the 'cam'. If the rotor was laid out horizontally, instead of vertically, springs could push the stators back in. This way, three are pulling at all times, while the cam lifts one of the stators.

Below is a pic showing what i'm talking about. I am artistically challenged, so no remarks about the quality of the pic. 

As this design calls for a horizontal setup, this is the top view.
The red things are the springs, the grey dots are the magnets, the blue thing is the cam, the large circle is the rotor. V track and magnet supports not shown.

Staffman,   It looks very promising.  I like the idea.   Nice art work.   

Bill

[roberval]

 When further studying the movement of the top arm, it bounces.
If the magnet was attracting it shouldn't bounce as it does.
the only explanation i can give is that the top bar repels,

perhaps the design has been purposely built to deceive, as the design of the top bar looks as if it attracts, it may only contain a small central magnet, and use an extension spring.
Unsure about the lower device, unless its not magnetic and shows it performs a little work.

[happyfunball]

@Clanzer .You are already so near with this we can SMELL it. On the video it looks like if you replaced your thumb with an adjusting screw , It would run as it is ! . Also you need to re-shape the cam , The bit that does the work has too steep a slope and is tending to push the magnet sideways instead of just lifting it . Put a little grease on this part of the cam . Another possibility is to mount the moving magnet on one end of a see saw , with an adjustable counterweight on the other end .  Hey man , what if it actually WORKS . The cat is out of the bag then .... Aren't you exited?

Are you serious? Clanzer's admirable attempt at a v-gate SMOT shows the obvious fact that it does not work. Not even close.

[Omnibus]

@ramset,

I'm back to this point -- I don't think there's a reason to contact Calloway. He hasn't done it at all. It's @Roobert33 who is important here. It would be worthwhile to talk to Calloway if he is @Roobert33. If he isn't I don't see any reason whatsoever for talking to him.