Kapanadze Cousin - DALLY FREE ENERGY

[lost_bro]

has any one seen this vid,    https://www.youtube.com/watch?v=yPvQOPNYiS4

it originally had another video showing how to make it, it has 80 turns primary  and the secondary is 5 +5, it obviously amplifies energy, think is has any one got the second video they can post ?

Many thanks Alien

Good day AlienGrey

Yes, very interesting video:

Here are links to both part 1 & part 2.

These are Wesley's translations so you can thank him for that!

https://www.youtube.com/watch?v=wMPU_9yIlXI

https://www.youtube.com/watch?v=OhJYDTGCoLs

take care, peace
lost_bro

[Dog-One]

Any comment on this snubber setup, is it adequate?

The snubber circuit there does work Itsu.  Depending upon how much reflection there is off the mismatch, the resistors may need to be pretty hefty.  I'm using 10 watt resistors, non-heatsinked and they typically don't get so hot as to unsolder themselves, but pretty close.  The better frequency match on your toroid core, the less those snubbers are needed.  Also, I dedicated a snubber resistor and capacitor for each MOSFET so I could tell which side of the waveform was producing the most reflection by which resistor was getting the hottest.

[AlienGrey]

Quote from: AlienGrey on Today at 01:58:31 AM

    has any one seen this vid,    https://www.youtube.com/watch?v=yPvQOPNYiS4

    it originally had another video showing how to make it, it has 80 turns primary  and the secondary is 5 +5, it obviously amplifies energy, think is has any one got the second video they can post ?

    Many thanks Alien


Good day AlienGrey

Yes, very interesting video:

Here are links to both part 1 & part 2.

These are Wesley's translations so you can thank him for that!

https://www.youtube.com/watch?v=wMPU_9yIlXI

https://www.youtube.com/watch?v=OhJYDTGCoLs

take care, peace
lost_bro
Logged
------------------------------------
Thanks for that !
Yes as i suspected, ITSU did an experiment of this (or tried to) I think he got a bit mixed up with resonance and multiples of it. Oh and sling that over heating cap away, Sorry mate!

Hope that helps

may the sun always shine on you

[itsu]

The snubber circuit there does work Itsu.  Depending upon how much reflection there is off the mismatch, the resistors may need to be pretty hefty.  I'm using 10 watt resistors, non-heatsinked and they typically don't get so hot as to unsolder themselves, but pretty close.  The better frequency match on your toroid core, the less those snubbers are needed.  Also, I dedicated a snubber resistor and capacitor for each MOSFET so I could tell which side of the waveform was producing the most reflection by which resistor was getting the hottest.

Dog-one,   Hoppy,

thanks, so that snubber arrangement works, it needs to be fed by an independent source so to avoid the 5 / 12 V regulators to be influenced, i will give it a try.

Nice build by the way Dog, very professional looking.


Regards Itsu

[Dog-One]

Nice build by the way Dog, very professional looking.

Thanks Itsu.  I built it quite a while back when I was naïve thinking everything would just pop together and work.  Seems there is a lot more to it than meets the eye.