Kapanadze Cousin - DALLY FREE ENERGY

[Hoppy]

Hoppy:
In regards to proof and videos no one have it good and sound. The poor quality videos and sketchy explanations are all what you got. People are not paid for making proof or high quality presentation so please stop whining and contribute own work instead.
Lets withhold accusations and trolling as it is not helping with progress and are only doing damage to cooperative sharing.

Yes, my rant was a little over the top so apologies. It winds me up keep seeing these poor quality and technically rubbish videos, so I will have to try harder to refrain from whining about them in future.

[TinselKoala]

Dear All.

May I present a sneak preview of RM Cybernetics SSTC demo ?


Quote.

"  Richard Morrow: It doesn't use caps in this setup. I get feed back from the RF GND so it always tracks resonance, then I can modulate it (pulse it) with another PWM signal of a few 10s of hz "

https://www.youtube.com/watch?v=vWDC_d6FDgI

This fully built circuit board will be available soon, please note, Tesla coil not included !!   

Might just be of use to the present research ??

Cheers Grum.

Sure, why not. Since I already demonstrated the same thing, 5 months ago.

http://www.youtube.com/watch?v=jeTlcroP0Ls

[AlienGrey]

Sure, why not. Since I already demonstrated the same thing, 5 months ago.

http://www.youtube.com/watch?v=jeTlcroP0Ls

Yes, i was so impressed with this device I made my own, I used a gated driver it's realy good too.
thanks for the intro Mr Tinsel Koala

[NickZ]

  If we look at the Ursa and Ypok devices, both of which are showing quite an increase in bulb brightness when the Kacher is connected up to the yoke/grenade circuit.  Both guys are showing long secondary coils (twice as long), for their Kacher/Tesla coil. This indicates that they are getting those long HV streamers due to their long secondary coil, which is producing very high voltage outputs.  But a scope reading would probably show no where near the normal 1.2Mhz to 1.7Mhz running frequency.  Most likely in the Khz range. And yet they are able to sync with the induction circuit.  However, it been a while now, since those videos were first shown, but, no self runners from the above circuits have been shown, as yet.

  Geo: What's new and exciting with your set up?

[itsu]

My laptop at the bench crashed when working with the kacher, so i was out of order for some time, also the current probe controller gives an error now.
The laptop is recovered, and in the mean time i was reworking the push-pull MOSFET setup to be like the latest ALLEGGA diagram as my drain signals were
not what they were somehow.




Jeg, 

this new snubber setup is not great, i had to add 54V TVS's (3x 18 in series) across each primary of the yoke to tone it down a bit,
but still there is massive ringing on each signal, see the screenshot.
It looks like my old setup signals.

Also to notice is that R26 (0.5W with me) gets very hot like you mentioned, so there needs to be a 5w resistor or so there.

When dismantling the old setup, i noticed that the both 47nF snubber caps (C12) i had in were toast, so thats probably the reason my old setup also had similar massive ringing.

Not sure what to do, leave it like this (yuk), or go back to the old setup with better 47nF caps in.


Regards Itsu