Kapanadze Cousin - DALLY FREE ENERGY

[dllabarre]

The Tesla coil building rules still apply here.  

The choke is your Tesla secondary, the coil wire providing current is your 1/4 length of choke with idealy 4 times wider wire for equal mass. We are dealing with mechanical(electrostatic) principles here.

Thank you T-1000.  I understand.

I assume L4 is wound on an air core like a tesla coil secondary?
DonL

[verpies]

Could the point be to steer us all in the wrong direction? So, that nobody will be able to replicate it. Maybe it is a self runner, but someone doesn't want that to be known, and this is all about that?

It could be.
For example by deceptively showing an aluminum tube with a wide slot, instead of a copper tube with a narrow slot (paper thin) or no slot at all, or wrong coil proportions, or not mentioning the ring ceramic magnets covered by the windings, etc...

This way next time somebody sees a tubular OU device with bunch of windings and a metal tube, he will run the other way...

[NickZ]

     Well, isn't it odd that on Akula's opening picture of the video of his device, it shows a flyback laying on the table next to the yokes, as well as a couple different commercial AC HV drivers.
  My feelings are that this device is not made by Tungus, Akula or any of the other guys showing the videos, nor is the hand drawn diagram akulas either.
  Until the real inventor shows up we are going to be chasing wind geese...
  So, I'm in the waiting room, with Itsu, for now.
                   
     NickZ

[MenofFather]

Akula schematic is seems that or very similiar. http://realstrannik.ru/media/kunena/attachments/3177/img0041.jpg
To drosel conected only capasitor, seems paralell. On mosfets is 220 volts. In other words two mosfets pumping 220 volts DC.

[NickZ]

   MenofFather and All:
   The hand drawn diagram is the same that is supposed to be from Akula 0083, but the top additional part is not the same (black ink). Hard for me to understand what is written there, maybe you can help. But, I don't want to get fooled by that diagram, as it may not work as shown, either. So, I'm trying to figure this out, myself, feeling my way in the dark.
   I've been studying some of Akula's previous videos, to see how he came to the conclusion of the last (self runner) video. He didn't get there overnight, or by himself.

   What I see is that the yoke is pulsed by a high voltage driver, which is connected to the center tap of the yoke. The yoke is acting as as step down transformer that increases the current, while dropping the high voltage. Then the three turns on the yoke should go to the big AC cap (possibly). Then further to the big air coil secondary.  That part of the big air coil looks similar to all the other replications of the Kapanadze, or kapagen device coils, with resonant coil, wound on top of the secondary coil. But instead of the copper tube wound around the big coil like most replications, the yoke is used as primary coil, but to raise the current that it gets from the HV pulse driver.
The unknown part must be in the drussel (choke) area, and what that does, and how. As there is no metal tube there.

  There are way too many Kapanadze/kapagen/Dally replications that are showing a  working self running device. Too many,  for them all to be fakes.
  Some of them have to be REAL!  If only just one is real, then it makes all this frustration all worth while. At least it does for me.

   NickZ