Kapanadze Cousin - DALLY FREE ENERGY

[Tomtech29]

Hi Tomtech,

I raised this issue way back as the reason I think for the increased bulb brightness when the Kacher switches on.

it is surplus tension due to Kacher within ^30 Vpp. Kinda strange how this affects the second heat sink it is (massive GND.)
everything goes back to normal operation.
- otherwise This pulses in the frequency to increase the current !
as it is due to translation or Akula:
https://www.youtube.com/watch?v=itk7Zl6tRSE&t=846s
This regulates the spark break.

[AlienGrey]

The 74HC14 in front with IR2110 driver and 2 3 pin terminals.. It looks like PLL with push-pull board

No it's the same card Memo put up ! it has TL494 and an IR101 and a 74HC132 rise time phase shift timer and pulse gen. Any way it does work and looks dead simple.

Have a look at scope shot Yellow is width of driver and phase position over power fet driver in Blue (1 half drive).
Dead easy to make.

[Enjoykin2017]

Hi Jeg 

[stivep]

https://www.youtube.com/watch?v=_8uUrjnW5w0

Wesley

[Jeg]

@AG, T1000
Guys i'd like to move to faster switching and i am looking for pwm controller and Mosfet driver able to run up to 2 or 3 MHz. Do you have any idea to experiment with? Any published circuits?  Thanks