Kapanadze Cousin - DALLY FREE ENERGY

[AlienGrey]

That's normal behaviour for two unsynchronized oscillators.

It's called jitter you can minimise it with a 'd' type or you could use a synth but not worth it on most things unless your doing video work.

A G

[conico]

Someone can explain what is in the picture?!
I saw in his movie two signals,  were are those signals from?

thank's!

[Dog-One]

This may be a little off-topic, but I'll try to make it as relevant as I can...

There is a phenomena with push/pull power convertors known as flux walking.
http://www.consult-cpr.com/Additional%20Pages/Eng%20LinksB7.html

If one attempted to apply this concept to an air-core transformer (such as
a Tesla coil or, uh hum, a grenade coil), what kind of effect might we manifest?

Now with a yoke core as Ruslan's device has, if we also have flux walking,
what effect might this have on the grenade coil?  We obviously should see
a current surge on the push/pull driver as we drive the yoke into saturation,
but suppose we don't (in a functioning system) and we know there is a DC
bias, what does that tell us?  Wouldn't it mean the stage after the yoke is
somehow correcting the flux imbalance?  And if it is, what must it be doing
to make that correction?


Just tossing this out there because I'm always looking for clues, wherever
I may find them, even if they are in the most unlikely places.

[boonk]

Someone can explain what is in the picture?!
I saw in his movie two signals,  were are those signals from?

thank's!

- this  is bifilar winding is wound three wires, and
push - pull (generator)  ... and, excitation from kacher
first when the generator is turned on   Lamp is very poorly lit,
with Kacher - bright..
oscilloscope: a first signal from generator, -  second from Tesla..

[Jeg]

That's normal behavior for two unsynchronized oscillators.

It's called jitter you can minimise it with a 'd' type or you could use a synth but not worth it on most things unless your doing video work.

Thanks for the info guys. Indeed they are unsychronized. The question is: Will this affect the output result when i'll drive this signal to a mosfet gate? Or it will be a necessity to use a synth as AG said? Any other advice on this? In my simple experimental circuit, a 555 with a low KHz frequency resets a second 555 while oscillating at higher frequency.