Kapanadze Cousin - DALLY FREE ENERGY

[Sergh]

I would like to see the wiring with the Dally schematic you made.

"wiring" for Dally "project"
Additional neodymium magnets should be mounted on the ferrite core of the "dumbbell" type.
They must be selected according to the maximum amplitude of the pulses. These magnets are not shown in the figure.

under yellow radiators there is a half-bridge on MOSFET with opto-drivers. Power supply voltage + - 250 volts (total 500V) Frequency up to 150 - 200 kHz modulated, duration ~2  ns, amplitude 1.5 - 1.7 kV at 50 Ohm load

[color]

Sergh:

Can you see the exact schematic and wiring diagram you are making?

Please post the exact name and capacity of your part.
 
Even if you publish a circuit diagram that does not work, your creative intellectual property rights will be protected.

[color]

Is this type of schematic?

[Hoppy]

Is this type of schematic?

Yes, this is the schematic I based my Daly build on. See early pages of this thread.

[Sergh]

Even if you publish a circuit diagram that does not work, your creative intellectual property rights will be protected.

if a person has  a lot of something, he doesn't appreciate it