Kapanadze Cousin - DALLY FREE ENERGY

[GeoFusion]

Hi Hoppy ok srry about that.
try these ones

1 https://za.gl/Gefusion

2 https://za.gl/GeoFusion

Cheers~

[AlienGrey]

still doesn't  do it, it gets lost 
this is colors tread
https://overunity.com/18143/colors-kapanadze-forum-fe-builds-circuits-and-comments/90/

Nick Color asked me to give you this or send it to you in fact to every one.

While I think of it that waveform https://1.bp.blogspot.com/-c4GEWtOh3k4/XEv0VZUX6MI/AAAAAAAAA4I/kud6wPog57cIqagYV_pS3lXbDa17SoYDACKgBGAs/s1600/Standing_wave_2.gif
it's not just a phase shift its also far more complex than that it's actually squeezing the Kacher winding as it's resonating.
That would require a very complicated control circuit to synthesize that, any ideas?

[GeoFusion]

Hi Nick,

Try to use the CT I posted down on the pic.
just like a normal toroid for current and see what difference it makes.

Oh and almost forgot, while you scope the ground CT
you will need to have the transistor (mosfet) being probed as well to
see when a pulse is given that you see a response back from earth each time when oscillations
stop. This is where we need to focus and see and to increase from there.
It will show when current builds up when reflection energy comes back from earth when resonating.

[NickZ]

   Geo, T-1000:   Here is a video that I made last night.  At the beginning of the video, it can be seen that the CT is showing 3.2MHz, at times.   https://youtu.be/u_gg73t5GaU
   Here is a pic of the CT, (air core this time). It was tuned previously to about 3.5MHz- to 4MHz. This was with NO Kacher running, just the induction circuits. With the Kacher on the CT voltage is higher, or course. I will show that next time.

[Hoppy]

Hi Nick,
Good work. You are showing a voltage across that 10 ohm resistor and therefore some current flow in your ground wire. Now try powering your setup from a battery and compare scope traces.