Kapanadze Cousin - DALLY FREE ENERGY

[NickZ]

  Other planet:
  You're going to have a 1000 questions in order to replicate Akulas device. And that yoke may not be all that optional, either.  In any case, check the previous post where Grumage, T-1000, and I tried to back engineer that circuit, on paper as well as on the work bench.
I'll still at it, now after 5 months of searching and experimenting. Have not given up hope just yet.  Maybe I should though. Ha!

[Nightmare_T34]

Ok. That should be it.
Now here's the thing . See where Red  questionmark is, close to the inverter. It seems like some element was cut out of the schematic! And on realstrannik Tiger said that ONE KEY ELEMENT is MISSING . And the device will work perfectly fine with it , but not without it .
Any guesses , gentlemen ? 

[Nightmare_T34]

Right now i'm downloading a rar with everything there is about Akula and his device (207mb) , will let you guys know what's in there.

[Nightmare_T34]

Not to keep you guys intrigued here or anything like that ... But I've found a couple of videos of Akula , that I've never seen anywhere.
Aslo his schematic of TL494 gen. . This particular one works from 7V input power up to 41V ...
About the videos - they are about arc welding from 12v transformer  . And he says that if you get it to resonate - it's going to melt the windings .... And a lot of interesting stuff.
I'll upload them tomorrow on youtube . If possible - with eng subs )

[Hoppy]

 
  Hoppy: A thick cable or wire is not needed to obtain KW of lights being lit. This has repeatedly been shown by Igor. 
Which also feels that Akula's second video may be using an induction oscillator hidden inside the house, and transfering the magnetic current through the single ground wire.
However there is no ground or any other wire in Akula's first video.  So... 
Only weed stems, and chair parts.  I didn't know they would work so well.

Nick,
We know that Igor uses an induction setup in the house and this is probably also the case with Akula. There is very likely a thin hidden wire in the case of Akula's setup but its very difficult to eyeball a thin wire on a grainy video that has been cleverly concealed. In the case of TK's 'box' devices, there is insufficient space for a local power supply capable of running the large lamp array, even though they are not lit to anywhere near full rated  power. Its possible that TK uses an HF/HV induction generator in the house but this would make the transmission of the power rather dangerous, given the crude and bare wire connections we see everywhere! The big iron transformers are the biggest clues to a low voltage, high current operation, especially the one in the transparent box device. Several posters have been of the firm opinion that the 'box' devices are not operating with an HV/HF Tesla coil type arrangement and I agree with them.