Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

hi Jeg,

I think you are right on using resistor 7.5ohms in parallel with diode for around 25volts supply.I do admit it's a uncommon setup.

150 ohms is more suited for around 600volts...1200volts coupled with hv diode.

Ruslan uses a 4007 diode in series with the capacitor. I used a quicker diode for being sure that will follow the quick oscillation. I intent to raise this 600khz to 2 MHz by using 6turns half primary, and lower capacitor. Do you know if the yoke ferrite will be able to follow this frequency?

[d3x0r]

Ruslan talking about various akula schematics... the last is a royer driver... but needs translation...

https://www.youtube.com/watch?v=7_z_cqygQK8

[NickZ]

  The Fet driver circuit is not really like the Royer, or Mazilli, nor even like what Akula uses. But, it looks simple enough, if it's just a cap in series with the IN4007 diode.  I don't see the two small 6.2v zeners that the previous diagram used.

  I don't understand most of that Ruslan is saying on the video. But, it looks like he's boxing up a new Akula type circuit, that he was still working on. Only two fans on the Fets, and no fan on the Kacher transistor. So the kacher crt must be able to run cool.

[d3x0r]

  The Fet driver circuit is not really like the Royer, or Mazilli, nor even like what Akula uses. But, it looks simple enough, if it's just a cap in series with the IN4007 diode.  I don't see the two small 6.2v zeners that the previous diagram used.

  I don't understand most of that Ruslan is saying on the video. But, it looks like he's boxing up a new Akula type circuit, that he was still working on. Only two fans on the Fets, and no fan on the Kacher transistor. So the kacher crt must be able to run cool.

D1/D2 are crossover diodes
D3/D4 are zeners... Z lines are kinda unclear but they are marked that way




https://www.youtube.com/watch?v=wBW_LuiY2ro  I guess this is 'romancorp' schematic implementation.  And no ground.

[MenofFather]

Hi MenofFather. Do you mean that Ruslan did not post that schematic?

Of cors.