Kapanadze Cousin - DALLY FREE ENERGY

[Jeg]

Jeg,  see picture,   10K pot and 1.5K for bias adjustment.

Regards Itsu

Thanks Itsu
Are your base and collector pulses clean as at ruslan's video?

[Jeg]

Enjoikin, look at page 395 my hand drawing with just a cap at the cathode of diode to ground.

[NickZ]

  Hoppy:
  At the end of this Kacher's secondary mag wire (below), but under the red tape connected to the ferrite rod. Looks like it could be braid???
  Sorry if we crossed topics...

  I'm still wanting know the right number of turns count (approximately), for the 20 gauge mag wire used in Ruslan's Kacher secondary coil. 
Also the number of turns on the additional insulated wire (or braid) that goes to the ferrite rod.  So, how many coil turns of the insulated wire (or flat copper wire, or braid), wound on the drain tube, under the red tape.
OR, do we just wind the 37.5 meters of mag wire for the secondary, and hope to be able to further tune to "Earth Frequency, using the ferrite tuning rod and these additional tuning coils in between the antenna and Kacher secondary coil?

[Enjoykin]

Jeg - I have two suggestions for you.

Tell me exactly about your bifilar inductor coil

a) winding directions
b) number of layers
с) lenght and wire diameter ??

[Jeg]

My exact inductor circuit is at the same drawing. But since then I omitted it as I tuned my system at the 28T side. This way grenade is loading more properly for me. My initial motivation was to first make the existed system more effective in terms of transferring power from yoke prim to grenade line.