Kapanadze Cousin - DALLY FREE ENERGY

[verpies]

Cannot see the 220uH inductor or the 20R resistor shown on the schematic in any of the photos. Were these components used by Dally?
It appears that Dally did not realise that the KT926 transistor cannot be driven properly from the 74HCT00!

I cannot see the 20Ω base resistor on any of the photos, either.

However, in the base path of KT926A, I can see pads for two SMD components (presumably the 20Ω resistor and the 1nF capacitor) on this and this PCB layout, but not on this older PCB layout.

On this photo I can see only one small SMD capacitor driving the KT926A base, in series.
On this photo there are PADS for only one SMD component in the base path but I am unable to see whether it is a resistor or a capacitor.

Conclusion from the older photos posted on Dally's Blog:  The base of the KT926A tranistor was driven by one small SMD component in series.

[Сергей В.]

@Verpies

Dally PCB.

You are right about neon resistor. His value didn't 100K but 1.8K or maybe 1K. I can't see correct second colour ring.

[Hoppy]

@Verpies

Dally PCB

Please convert to .jpg format.

Regards
Hoppy

[Сергей В.]

Message from Dally 25 Октября 2012 г

The green transformer is not the most important stuff, soon will be the video of new device with new self-made transformer on ferrite ring.

And still it would be desirable to tell you:
For envious persons, on this project I have got donation 2300 rubles which I spent for a wire for new device.
Separate thanks to all people which gave donation to me.

This project further remains NOT commercial!
For........, threats on me have no influence at all!

[Сергей В.]

Привет Hoppy

You don't need .jpg picture becuase you can print directly from Sprint Layout on your laser printer. Program automatic madew mirroring of bottom layer and also you can trimming tiles horizontally and vertically. Do you want to upload it here ??

Regards