Overunity.com Archives is Temporarily on Read Mode Only!



Free Energy will change the World - Free Energy will stop Climate Change - Free Energy will give us hope
and we will not surrender until free energy will be enabled all over the world, to power planes, cars, ships and trains.
Free energy will help the poor to become independent of needing expensive fuels.
So all in all Free energy will bring far more peace to the world than any other invention has already brought to the world.
Those beautiful words were written by Stefan Hartmann/Owner/Admin at overunity.com
Unfortunately now, Stefan Hartmann is very ill and He needs our help
Stefan wanted that I have all these massive data to get it back online
even being as ill as Stefan is, he transferred all databases and folders
that without his help, this Forum Archives would have never been published here
so, please, as the Webmaster and Creator of these Archives, I am asking that you help him
by making a donation on the Paypal Button above.
You can visit us or register at my main site at:
Overunity Machines Forum



Kapanadze Cousin - DALLY FREE ENERGY

Started by 27Bubba, September 18, 2012, 02:17:22 PM

Previous topic - Next topic

0 Members and 34 Guests are viewing this topic.

verpies

Quote from: NickZ on May 18, 2013, 12:04:46 AM
I use a single light bulb, and a garden solar light photo resistor tapped to the bulb, and connected to my volt meters ohm setting, to gauge the bulb brightness, by the given resistance value.
That's great!
I wish everyone was doing that instead of dumbly multiplying non-DC Volts times non-DC Amps.
Also, if you use an incandescent light bulb with non-coiled filament then your power measurements will be accurate even it high frequencies.

...and if you calibrate the bulb's brightness with known DC then you will be able to measure power in absolute units (Watts).
Warning: It is not linear - see here.

Hoppy

Quote from: verpies on May 18, 2013, 07:26:46 AM
That's great!
I wish everyone was doing that instead of dumbly multiplying non-DC Volts times non-DC Amps.
Also, if you use an incandescent light bulb with non-coiled filament then your power measurements will be accurate even it high frequencies.

...and if you calibrate the bulb's brightness with known DC then you will be able to measure power in absolute units (Watts).
Warning: It is not linear - see here.

Yes, this should form an integral part of all the fundamental experiments encouraged by Tiger.


T-1000


Hoppy

Quote from: T-1000 on May 18, 2013, 09:00:13 AM
Nice N. Tesla wireless power transmission tricks! :D

This is how the magician refines his art  ;)

verpies

Quote from: Hoppy on May 18, 2013, 09:04:44 AM
This is how the magician refines his art  ;)
I like the one with the narrative about a mysterious briefcase being left on his doorstep.
I forgot the URL to it though.