Kapanadze Cousin - DALLY FREE ENERGY

[forest]

@OVERUNITY FORUM ADMINISTRATOR
Kapanadze Cousin - DALLY FREE ENERGY Webpage 126 is showing a blank page or disappeared from dally free energy forum.  Please solve this problem...

YEAH !!!!!!!!

[forest]

Может из-за технических ошибок пропала страница, то выкладываю, что было на ней. http://www.speedyshare.com/x3Bnq/akulac.png
Это схема похожа на настоящую, но тот который её выставил (Сергей), сказал, что не Акула её прислал ему. Поэтому от куда он её взял непонятно.

Broken png file ??

[forest]

Note that this circuit has ferrite cores in all transformers.
No empty air coils - no energy from air (or vacuum).

Quite opposite. Why do you think ferrite would forbid tapping energy from ether ?

[Grumage]

Was this on page 126?

Dear all.

Yes it was, but an amended one!!

Cheers Grum.

[TEKTRON]

    @ Cepren B:
    I have e-mailed Akula with pictures and explanations of where I'm at with all this, and asking for his help.  But, got No reply.
   I know that some of the Russians know about this stuff,  I KNOW THAT. 
   So, thanks for your questions, Cepren B.
   
   As you can see my comrades don't believe what they see with their own eyes, they think it's only tricks, and fakes, as the cause of it all. That there is no such thing as energy in the ambient, only energy in mass. They don't know that mass is created from energy, not the other way around.
Can you see what I'm up against? Not easy?
Yes it is easy. "So easy you'll laugh".  But, WE just don't understand it, yet. 
  Just look at Stepanov's device out in the snow, and how simple it is, again using old junk parts.
  But, no one believes it!
  Any way, here are some pictures of what I've done so far. I know that it's not right, and not finished yet, but it is what I have to work with. No expenses at all were made on my part.  Zilch! 

  I have explained previously that I am not getting any real current output after my three turn yoke coil.
I don't have the right capacitors yet, and I don't know which ones I really need.
The diagram that was made by T-1000, which I added my ideas to just recently, of how I think that it all goes, is what I am thinking of doing or following,  but don't know about the driver circuit that Akula is using.
Anyway this is what I have.

Nick, I have just noticed that your center tapped primary is counter wound from center tap as apposed to what Akula did. look at the vid "Использование резонанса в сварочном" again. look at the red ends, not the center tap. it is ALL one one direction from start to finish. aprox vid time 00:20