Kapanadze Cousin - DALLY FREE ENERGY

[itsu]

Nick,  something is wrong here.

the second picture (0.47uF signal. jpg) is the same picture as in an earlier post of you here:
http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg461330/#msg461330

That one had a different timebase setting (20us/div.) then, so please double check your screenshots.

Regards Itsu

[Hoppy]

Forrest, Hoppy   that's exactly what I mean.  As I said before, I put my Ruslan's replication  on hold and do small experiments with radiant charging , experiments with cap/coils, effect of grounding on the system etc. 

With respect to what Acula says in that movie the most important element is an "inductor" between the Tesla and it's Antenna to get sharp face pulse (He says his pulse shoots over 30KV)  So, can you replicate this? Actually, is it even possible to sharp the front face of the sinus wave by inductor??

I would like to see a good description of the 'effect' being striven for. I saw a marked increase in bulb brightness with my first build when the kacher was energised but this turned out to be caused by HV affecting the PWM switching transistors. I assume that the effect can be observed without the device in loop-back / self-running mode. There are too many gaps in my knowledge to make it worthwhile to re-start building by guesswork and too much unnecessary time wasting as a consequence. I like your approach John, small experiments to gain a better understanding.

[NickZ]

Nick,  something is wrong here.

the second picture (0.47uF signal. jpg) is the same picture as in an earlier post of you here:
http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg461330/#msg461330

That one had a different timebase setting (20us/div.) then, so please double check your screenshots.

Regards Itsu

   Itsu: That is correct, it's the wrong image which was made previous to installing the new WIMA 1600v, 0.47 turning cap.
  The right image taken yesterday, has replaced it, now, in the edit made to the same post.  Sorry about that.
   

[itsu]

Nick,

thats better, so we have for both, 20 cycles in 8 divisions (set at 100us/div.), so doing it the correct / Tinsel way:

20 cycles in (8 x 100 microseconds) = 20/(8 x 0.000100) = 25000 cycles per second = 25 KHz

So your mazilla, inductor and Grenade are running at 25 KHz there.

Regards itsu

[magpwr]

hi everyone,

Taking a look at the 720p Akula video as posted by Nickz.

I have made latest discovery related to where Akula obtained the waveform as was shown in his circuit diagram base on this Tesla coil tuning video video 720p -

www.youtube.com/watch?v=fp3sed_eli0

13.27minute into video 17.xxkhz as shown in attachment.

14:14minute into video obtained as low as 3.1khz (Scope Time div setting at 50us)

With this findings i hope anyone whom is competent enough is able to decode further without theories.
-----------------------------------------------------------------------
Related to FE i have just finished designing 7KV 60ns..80ns 220khz circuit board.28volts -7volts gate drive for 1.2kv Cree SIC mosfet.
I am left with planning a new design for my "isolated" variable HV supply to be placed onto existing PCB.

-------------------------------------------------
I hardly get involved into this forum these days one of the reason being i am no Ruslan supporter.Hence i do get turn off just by the mention of his name every time.