Kapanadze Cousin - DALLY FREE ENERGY

[AlienGrey]

I am wondering if this is the missing part of the Kapanadze puzzle.


Any constructive comments??


http://crystalradioinitiative.com/

I believe the FE diagram is here http://www.gestaltreality.com/energy-synthesis/eric-dollard/additional-posts-by-e-p-dollard-2012/

Yes i Have, if your serious about getting this device to work i suggest you get this information it does explain a hell of a lot, other wise your just pissing in the wind, happy tinkering to all
After thought, The video did have a link on the energetic forum but has since been taken down since 'DOG posted this info'. the book is also a video and is protected by copy right. happy days to all

[Jeg]

Itsu or anyone
Do you know what this R26 resistance is for? Won't mess with the 24V supply to the primaries?

[T-1000]

Itsu or anyone
Do you know what this R26 resistance is for? Won't mess with the 24V supply to the primaries?

The BEMF from yoke is charging capacitor C15 over diodes VD6/VD7 and the resistor R26 is just dumping charge. That is conventional part of inverters(no energy recovery). Also the R26 should be 0.5W or more as there is quite power going to discharge.

[Jeg]

The BEMF from yoke is charging capacitor C15 over diodes VD6/VD7 and the resistor R26 is just dumping charge. That is conventional part of inverters(no energy recovery). Also the R26 should be 0.5W or more as there is quite power going to discharge.

Thanks T1000. Never seen this before

[NickZ]

   Ok, so I've taken my Kacher circuit's running frequency for a ride, from it's starting point of 500khz, up to 3.3Mhz. And, now I've brought it's frequency down again to be the same as the self resonant frequency of my grenade's output coil is at, which is 1.81Mhz. 
  I'm now seeing the 20w 220v microwave bulb, and another small 10w 120v incandescent bulbs both lit up (glowing), as well. These bulbs are connected to both the induction circuit, as well as at the grenade output coil. Also the HF stinging, and small 1-2mm streamers felt at ALL the coils ends.  Have not yet reached the 3mm streamer I had at one time. But, the HV sparks are strong enough to make me toss a bulb across the table. 
  The Kacher circuit can now light a CFL bulb near to 15 inches away from the antenna coil. And light a 4 foot florescent tube almost two feet away. So far,  soooooo good.