Kapanadze Cousin - DALLY FREE ENERGY

[Dog-One]

  Seams like this guy Y pok has obtained the "effect".  And is showing what I had always wanted Akula and Ruslan to show. Only he has only one bulb as the load, and no feed back loop yet.
https://www.youtube.com/watch?v=faCaYvh69Bs

Good video Nick!  It definitely shows how the two major components integrate into increased output.

Too bad he doesn't speak English or you Russian because it appears the two of you guys are exactly on the same page.

[John.K1]

I is that same guy Tomtech was posting before and his YouTube series Iwant to watch from 01 to 23. All already downloaded.

[John.K1]

In the above video, you can see where he puts his probes -  one is on the current sense transformer ,checking current - second one is on the granade coil (+ 20w bulb)  ,cecking voltage.

He switch first only kacher and see the current and voltage are in face (he tunes frequency with ferite rod inside  the tube) , than he switch only 30 KHz PushPul and check the same-they are in face. Last he connected both together.  His next step will be the synchronization.

He also showed that correct/incorrect  seting on your scope made looks the picture different.

BTW-i n his setup he has ground cable only to Kacher and through the capacitor.

[verpies]

@Itsu

You can pull on pin9 of the CD4046 like in this video to inject a phase offset into the PLL and see for yourself how the AC voltage source transfers energy to the LC circuit at various phases.

[itsu]

  Seams like this guy Y pok has obtained the "effect".  And is showing what I had always wanted Akula and Ruslan to show. Only he has only one bulb as the load, and no feed back loop yet.
https://www.youtube.com/watch?v=faCaYvh69Bs

Nick,  John,

i see nothing special in that video, at least nothing special that we have not seen before.
Both Hoppy and me have shown about 1 year ago to obtain the "effect" which is that the kacher and push/pull oscillator together increase the lightning on a bulb on the grenade.

When looking back to that period (around pages 420 etc.) i also see that even then my (and Hoppy's) current transformer is clearly peaking on the VOLTAGE, not the CURRENT, see f.i. this post:
http://overunity.com/12736/kapanadze-cousin-dally-free-energy/msg422291/#msg422291

There you again see the side by side comparison of my current probe (picking up the real current 90° out of phase with the grenade voltage) and the current transformer (peaking on the Grenade voltage).

So i am pretty sure that we need to fire the kacher ontop of the inductor/grenade VOLTAGE peak, NOT on the current.


Regards Itsu