Kapanadze Cousin - DALLY FREE ENERGY

[conico]

I believe you must find the resonant frequency of the yoke first and make coils after.
I try a coil on a half of the yoke and is not the same inductance when the both parts of the yoke are together.
I don't know how to find the resonant frequency of the yoke, may be someone can tell us.

[Void]

I believe you must find the resonant frequency of the yoke first and make coils after.
I try a coil on a half of the yoke and is not the same inductance when the both parts of the yoke are together.
I don't know how to find the resonant frequency of the yoke, may be someone can tell us.

Hi conico. See this video made by Wesley:
http://www.youtube.com/watch?v=bJWxJsaxNvE

This video gives an overview of how they searched for the magic frequency.
They used a spectrum analyzer connected to the output winding and applied
a white noise signal or swept through the frequencies with a square wave signal
connected to the copper foil or to an input winding. They found a peak at about 1.2 MHz
which seemed to be something other than just an ordinary resonant peak due to resonance
in a coil.

[conico]

thank you !

[T-1000]

Hi conico. See this video made by Wesley:
http://www.youtube.com/watch?v=bJWxJsaxNvE

This video gives an overview of how they searched for the magic frequency.
They used a spectrum analyzer connected to the output winding and applied
a white noise signal or swept through the frequencies with a square wave signal
connected to the copper foil or to an input winding. They found a peak at about 1.2 MHz
which seemed to be something other than just an ordinary resonant peak due to resonance
in a coil.

I just replied in http://overunity.com/4333/meyer-mace-isotopic-nmr-generator/msg473160/#msg473160
I think that thread is more appropriate for that discussion so we can keep Dally thread clean from mixed topics.

P.S. You may read entire thread there.

Cheers!

[verpies]

I have to wonder how T-1000 and his group were able to do that without damaging their signal generators.

As far as I remember they did blow it up and there was a long pause in their experiments while they were getting a replacement.

Yes, I think that in order to get 150 turns on the output winding you would need about three layers
of windings.

I distinctly remember 2 layers.