Kapanadze Cousin - DALLY FREE ENERGY

[Void]

Hi Void,

Its not a case of being mentally handicapped, rather the team being physically handicapped by not being allowed to disconnect the earth braid to inspect it properly. As I understand from a.king212, the team did go fully equipped to take measurements and yet we see no measurements being made or earth wire disconnected for close-up inspection because the team were prevented from carrying out any invasive tests that could have established whether the device was a genuine self-runner.

Hi Hoppy. I have been teasing a bit, but that would be quite the critical oversight to go all
the way over there and not have it as a requirement to be able to see the ground lug disconnected
and up close, either right before the demo started or right at the end of the demo. I can't imagine
what the point would be to go over there if they had not been allowed to see the ground wire disconnected.

If they weren't allowed to inspect the ground wire and the ground lug while disconnected, that would of course
be highly suspicious, and I can't see anyone agreeing to that; but, as always, anything is possible I suppose.
Of course just because something may not have been shown in any publicly posted video clips, it doesn't
mean it didn't happen. One of the people who attended such a demo in person would have to confirm
before I would be convinced that they didn't insist on seeing the ground wire disconnected up close at either
the start of the demo or at the end of the demo. I think anyone would make that a non-negotiable requirement
for a demo, or otherwise there would be no point going over there. That would be an essential demo step.

[Hoppy]

If they weren't allowed to inspect the ground wire and the ground lug while disconnected, that would of course
be highly suspicious, and I can't see anyone agreeing to that; but, as always, anything is possible I suppose.
Of course just because something may not have been shown in any publicly posted video clips, it doesn't
mean it didn't happen. One of the people who attended such a demo in person would have to confirm
before I would be convinced that they didn't insist on seeing the ground wire disconnected up close at either
the start of the demo or at the end of the demo. I think anyone would make that a non-negotiable requirement
for a demo, or otherwise there would be no point going over there. That would be an essential demo step.

I agree with your logic but equally, if they did inspect the disconnected ground wire and lug, then why do we see a video with the most important part excluded. The only logical conclusion I can come up with, is that the team did go equipped with the intention to carry out a full test and inspection but were prevented from doing so.

[Void]

I agree with your logic but equally, if they did inspect the disconnected ground wire and lug, then why do we see a video with the most important part excluded. The only logical conclusion I can come up with, is that the team did go equipped with the intention to carry out a full test and inspection but were prevented from doing so.

Hi Hoppy. What they decided to video record and what video clips they decided to post
publicly would be totally up to them. I don't think you can at all reasonably draw any conclusions
from what just was seen in some publicly posted video clips kicking around.

I can fully understand why Kapanadze would not allow any measurements using measurement equipment
while the device was running, as any such measurements could potentially help someone figure out
how his device works. However, there would be no reason for Kapanadze to not allow inspection of the ground
lug and ground wire while the ground wire was disconnected, either right before or right after the demo, and I
would expect anyone who went to all the trouble to arrange such a demo and go over there would have made
that ground wire and ground lug inspection a non-negotiable requirement for the demo. That would just be a no-brainer.

Since there would be no reason for Kapanadze to refuse such a request if he didn't have any hidden wires in
the ground wire, for Kapanadze to refuse such a request would be tantamount to admitting that he had something
to hide there. I just can't see anyone going over there for a demo and not making it a requirement to inspect the
unconnected ground wire and ground lug up close, in any way they pleased.  As always, anything is possible however,
even if it does appear quite unlikely.

[Hoppy]

Void wrote: -

"I just can't see anyone going over there for a demo and not making it a requirement to inspect the
unconnected ground wire and ground lug up close, in any way they pleased."

Agreed, but the key question is: was the request made as a condition before the visit or was it simply assumed that there would be no objection given the system would not be running for this inspection. 

[Sustainable]

Hi everyone.  I been reading everyone's post for few years now ,mainly to learn more about experiments etc. I'm nowhere near experienced . I would be somewhat at joule ringer stage rather than searching for resonance.  Just to bring something to everyone's attension.  In all kapanadze videos there was a spark gap with plasma arcing.  But in last video I see the spark gap but no spark.  If that's the case ,what is driving the tesla coil?